Installation Guide

Activating your warranty only takes a moment and ensures that we
are able to offer the best service possible to you. Visit us at
www.thermablaster.com or you can use the mail in form at the back
of the product manual.
REGISTER TODAY!
18” Vent Free Gas Log
Model: GLDF18T-VF
Dual Fuel
Adjustable temperature settings determine the length of time that
the heater will operate at maximum BTU to achieve desired temperature,
not the actual flame height.
During first seasonal use, gas smell is expected to be more noticeable than in
standard operation.
Operation Notes:
To stop the heater, shut off the safety valve on the gas inlet line. Then,
turn the heater’s Gas Valve Button to the OFF position.
Shutdown Process:
5. The heater will now operate normally. You should adjust the Control
Knob to your desired heat setting. Room temperature will vary based
on individual room size and installation.
4. Once the pilot flame is stable, turn the Control Knob counterclock
wise from the Pilot setting to the desired number setting. This
should be done slowly in one motion, without stopping between
positions. Knob will only turn if you have a stable pilot light.
3. Release both buttons. Should the pilot go out, repeat steps 2 and 3.
2. With the Control Knob set to Pilot, push down on both the Igniter
Button and the Control Knob simultaneously until ignition can be
heard. Continue to hold down both buttons for at least 15 seconds,
until the pilot is touching the thermocouple and is noticeably
heated.
1. During the first seasonal operation, set the Control Knob to Pilot, then
hold down on the Control Knob for 3-5 minutes. This allows the air in the
manifests to clear completely. During normal operation, you will only
need to hold the Control Knob down on Pilot for about 5 seconds
Ignition Process:
Follow these steps to ensure that your heater
is running the right way, every time.
Operational Instructions
Igniter Button
Control Knob