Instructions for Use
Table Of Contents
- Table of Contents Use and care manual
- IMPORTANT SAFETY INSTRUCTIONS
- READ AND SAVE THESE INSTRUCTIONS
- WARNING
- Fire Safety
- WARNING
- to reduce the risk of a grease fire:
- a. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
- b. Always turn hood ON when cooking at high heat or when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).
- c. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
- d. Use proper pan size. Always use cookware appropriate for the size of the surface element.
- WARNING
- TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A GREASE FIRE, OBSERVE THE FOLLOWING:
- a. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
- b. NEVER PICK UP A FLAMING PAN – You may be burned.
- c. DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.
- d. Use an extinguisher ONLY if:
- Cooking Safety
- Burn Prevention
- Child Safety
- Cleaning Safety
- Cookware Safety
- Proper Installation and Maintenance
- Electromagnetic interference
- Cooling fan
- Proposition 65 Warning:
- Causes of damage
- Protecting the Environment
- Cooking with Induction
- Getting familiar with the appliance
- Operation
- Main power switch
- Setting the cooktop
- Setting the element
- Selecting the heat level
- 1. Select the desired element by touching the corresponding words printed on the control panel. In the element display ‹ and the __ indicator light up.
- 2. Within the following 10 seconds, set the desired power level using the number keys.
- 3. To change the power level, select the element and set the desired power level using the number keys. To set an intermediate level touch the + symbols next to the number key 9.
- Turning off the element
- Notes
- Recommendations
- Settings table
- 9 CAUTION
- PowerBoost® function
- Cook time
- Kitchen timer
- Panel lock
- Wipe Protection
- Automatic time limitation
- Basic settings
- --------
- Changing the basic settings
- 1. Turn on the cooktop with the main switch.
- 2. Within10 seconds, touch the TIMER key for about 4 seconds.
- 3. Touching the TIMER key again takes you to the basic settings.
- 4. Touch TIMER repeatedly until the indicator for the desired function appears in the element display.
- 5. Select the desired setting using the number keys.
- 6. Touch TIMER again for 4 seconds. The setting is stored.
- Quit basic settings
- Cleaning and Maintenance
- Service
- Frequently-asked questions and answers (FAQ)
- Fixing Malfunctions
- How to Obtain Warranty Service
- STATEMENT OF LIMITED PRODUCT WARRANTY
- THERMADOR® Support
- READ AND SAVE THESE INSTRUCTIONS
- Table des Matières Notice d’utilisation
- 9 Définitions de sécuritéDéfinitions de sécurité
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- LIRE ET CONSERVER CES INSTRUCTIONS
- AVERTISSEMENT
- Sécurité-incendie
- AVERTISSEMENT
- POUR RÉDUIRE LES RISQUES DE FEUX DE GRAISSE :
- a. Ne jamais faire fonctionner les unités de surface à des températures élevées sans surveillance. Des débordements causant de la fumée et des déversements graisseux peuvent prendre feu. Chauffer l'huile lentement à réglage faible ou moyen.
- b. Mettre toujours la hotte EN MARCHE pendant la cuisson à température élevée et au moment de flamber des aliments (p.ex., crêpes Suzette, cerises jubilée, steak au poivre flambé).
- c. Nettoyer souvent les ventilateurs d'aération. Il ne faut pas que la graisse s'accumule sur le ventilateur ou sur le filtre.
- d. Utiliser des casseroles de taille adéquate. Utiliser toujours des casseroles dont les dimensions conviennent à la taille de l'élément.
- AVERTISSEMENT
- POUR RÉDUIRE LE RISQUE DE LÉSIONS CORPORELLES DANS L'ÉVENTUALITÉ D'UN FEU DE GRAISSE, OBSERVER LES CONSIGNES SUIVANTES :
- a. ÉTOUFFER LES FLAMMES à l'aide d'un couvercle bien hermétique, d'une tôle à biscuits ou d'un plateau en métal, puis éteindre l'appareil. FAIRE ATTENTION À NE PAS SE BRÛLER. Si les flammes ne s'éteignent pas immédiatement, ÉVACUER LES LI...
- b. NE JAMAIS SAISIR UN RÉCIPIENT QUI BRÛLE. Vous pourriez vous brûler.
- c. NE PAS UTILISER D'EAU, y compris les chiffons ou serviettes mouillées. Une violente explosion de vapeur risque de se produire.
- d. Utiliser un extincteur uniquement si :
- Sécurité de cuisson
- Prévention des brûlures
- Sécurité des enfants
- Consignes en matière de nettoyage
- Sécurité pour la batterie de cuisine
- Installation et entretien corrects
- Perturbations électromagnétiques
- Ventilateur de refroidissement
- Avertissement issu de la proposition 65 :
- Éléments qui peuvent endommager l'appareil
- Protection de l'Environnement
- Cuisson par Induction
- Faire connaissance avec l’appareil
- Fonctionnement
- Interrupteur d'alimentation principal
- Allumage de la table de cuisson
- Réglage de l'élément
- Sélection du niveau de chaleur
- 1. Sélectionne l'élément souhaité en effleurant les mots correspondants imprimés sur le panneau de commande. Sur l'écran de l'élément, ‹ et le témoin __ s’allument.
- 2. Dans les 10 secondes qui suivent, réglez le niveau de puissance souhaité avec les touches numérotées.
- 3. Pour modifier le niveau de puissance, sélectionnez l'élément et réglez le niveau de puissance souhaité avec les touches numérotées. Pour régler un niveau intermédiaire, touchez les symboles + adjacents à la touche numérotée 9.
- Désactivation de l'élément
- Remarques
- Recommandations
- Tableau des réglages
- 9 ATTENTION
- Fonction PowerBoostMD
- Durée de cuisson
- Minuterie de cuisine
- Verrouillage du panneau
- Protection contre l'essuyage
- Durée limitée automatique
- Réglages de base
- Nettoyage et Entretien
- Entretien
- Foire aux questions (FAQ)
- Corrections des défaillances
- Comment bénéficier du service de garantie
- ÉNONCÉ DE LA GARANTIE LIMITÉE
- Soutien THERMADOR®
- Contenido Manual de instrucciones
- LIRE ET CONSERVER CES INSTRUCTIONS
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- LEA Y CONSERVE ESTAS INSTRUCCIONES
- ADVERTENCIA
- Seguridad para evitar incendios
- ADVERTENCIA
- PARA REDUCIR EL RIESGO DE INCENDIO OCASIONADO POR GRASA:
- a. Nunca deje las unidades de la superficie sin vigilancia a valores altos. Los derrames por hervor causan humo y salpicaduras grasosas que pueden prenderse fuego. Caliente los aceites despacio, a valores bajos o medianos.
- b. Siempre encienda la campana al cocinar a un valor de calor alto o al flambear alimentos (p. ej., Crepas Suzette, cerezas Jubilee, carne flambeada con granos de pimienta).
- c. Limpie los ventiladores extractores con frecuencia. No se debe permitir la acumulación de grasa en los ventiladores ni en los filtros.
- d. Use el tamaño adecuado de olla. Siempre use utensilios de cocina apropiados para el tamaño del elemento de la superficie.
- ADVERTENCIA
- PARA REDUCIR EL RIESGO DE LESIONES A PERSONAS EN CASO DE INCENDIO OCASIONADO POR GRASA, SIGA ESTAS INDICACIONES:
- a. SOFOQUE LAS LLAMAS con una tapa que ajuste correctamente, una placa para galletas u otra bandeja de metal, luego, apague el electrodoméstico. ASEGÚRESE DE PREVENIR LAS QUEMADURAS. Si las llamas no se apagan de inmediato, EVACUE EL ÁREA Y LLAME ...
- b. NUNCA LEVANTE UNA OLLA EN LLAMAS. Puede quemarse.
- c. NO USE AGUA, ni repasadores o toallas húmedos. Puede ocasionar una violenta explosión por vapor.
- d. Use un extinguidor sólo si:
- Seguridad al cocinar
- Prevención de quemaduras
- Seguridad de los niños
- Seguridad en la limpieza
- Seguridad en los utensilios de cocina
- Instalación y mantenimiento adecuados
- Interferencias electromagnéticas
- Ventilador de refrigeración
- Advertencia en virtud de la Proposición 65:
- Elementos que pueden dañar el electrodoméstico
- Protección Medioambiental
- Cocción por Inducción
- Para familiarizarse con la unidad
- Operación
- Interruptor de alimentación eléctrica principal
- Para encender la placa
- Ajustar el elemento
- Seleccionar el nivel de calor
- 1. Seleccionar el elemento deseado pulsando las palabras correspondientes impresas en el panel de control. En el display del elemento ‹ y la indicación visual __ se encienden.
- 2. En el término de los 10 segundos siguientes, programar el nivel de potencia deseado con las teclas numéricas.
- 3. Para cambiar el nivel de potencia, seleccionar el elemento y ajustar el nivel de potencia deseado con las teclas numéricas. Para ajustar un nivel intermedio, pulsar los símbolos + junto a la tecla numérica 9.
- Apagar el elemento
- Notas
- Recomendaciones
- Tabla de valores
- 9 ATENCION
- Función PowerBoost®
- Tiempo de cocción
- Temporizador de cocina
- Bloqueo de panel
- Protección de limpieza
- Limitación automática de tiempo
- Valores básicos
- Limpieza y Mantenimiento
- Servicio técnico
- Preguntas y respuestas frecuentes (FAQ)
- Arreglar fallas en el funcionamiento
- Cómo obtener el servicio técnico de la garantía
- DECLARACIÓN DE GARANTÍA LIMITADA DEL PRODUCTO
- Soporte técnico de THERMADOR®
- LEA Y CONSERVE ESTAS INSTRUCCIONES
8
Causes of damage
NOTICES
▯ Scratches on glass ceramic surface: Cookware with
rough bottoms will scratch the glass ceramic surface.
▯ Salt, sugar and sand: Salt, sugar or grains of sand will
scratch the glass ceramic surface. Never use the
cooktop as a working surface or for setting things
down.
▯ Overheated cookware: Avoid heating pots or pans
that are empty.
▯ Hot cookware: Never set down hot pans and pots on
the control panel or frame. This may cause damage.
▯ Hard and sharp objects: Hard or sharp objects falling
on the cooktop may damage it.
▯ Boiled-over food: Sugar and products containing
sugar may damage the cooktop. Immediately eliminate
spills of these products with a glass scraper.
▯ Foils and plastics: Aluminum foil and plastic will melt
on the hot cooking zones. Stove protective film isn't
suitable for your cooktop.
▯ Unsuitable cleaning agent: Shimmering metallic
discolorations on the glass ceramic surface result from
the use of inappropriate cleaning agents and abrasion
from cookware.
Protecting the Environment
Energy-saving advice
▯ Always place a fitting lid on cookware. Cooking with
an uncovered pan will result in a four-fold increase in
energy use. Use a glass lid to provide visibility and
avoid having to lift the lid.
▯ Use cookware equipped with a solid, flat bottom.
Curved pan bases increase energy consumption.
▯ The diameter of the pan base must match the size of
the element. If not, energy may be wasted. Note: The
manufacturer normally indicates the pan's upper
diameter. This is normally greater than the diameter of
the pan's base.
▯ Choose cookware of a size suited to the amount of
food you are going to cook. A large pan that is only
half full will use a lot of energy.
▯ Use a small amount of water when cooking. This
saves energy, and vegetables retain a larger
percentage of their vitamins and minerals.
▯ Select a lower power level.
Cooking with Induction
Advantages of induction cooking
Induction cooking is very different from traditional
cooking methods, as heat builds up directly in the item of
cookware. This offers numerous advantages:
▯ Saves time when boiling and frying.
▯ Saves energy.
▯ Easier to care for and clean. Spilled food does not
burn on as quickly.
▯ Heat control and safety – the cooktop increases or
decreases the heat supply as soon as the user
changes the setting. The induction element stops the
heat supply as soon as the cookware is removed from
the element, without having to switch it off first.
Cookware
Only use ferromagnetic cookware for induction cooking,
such as:
▯ Cookware made from enameled steel
▯ Cookware made from cast iron
▯ Special induction-compatible cookware made from
stainless steel.
To check whether your cookware is suitable for induction
cooking, refer to the section on ~ "Suitability test of
cookware".
To achieve a good cooking result, the ferromagnetic area
on the base of the pan should match the size of the
element. If an element does not detect an item of
cookware, try placing it on another element with a
smaller diameter.
FP
FP
FP
LQ
LQ
LQ