Installation instructions

8
• Pull the drain hose out of the packaging base as shown.
• Set toe panel aside for later use.
b
a
4
• Attach elbow connection to dishwasher as shown. Do
not overtighten.
NOTICE : Avoid cross-threading! It will cause leaks. After
attaching hose, turn on water and check for leaks.
• Attach hot water line to elbow.
Note: For a easier access to the hot water inlet connection,
tip unit slightly forward with someone holding the front side
of the unit.
5
• Remove the hose clip at the back of the dishwasher as
shown. The hose clip may be used later to hold the drain
hose inside your cabinet.
6
b
a
DO NOT tip the dishwasher too far forward! This
could cause serious injury or death. Always have an
adult hold the front side if the unit is tipped.
WARNING
!