User Manual

en-us Faults – what to do?
16
3 Faults – what to do?
Faults – what to do? Before you call customer service, use this table to check whether you can rectify the fault yourself.
Appliance
--------
Ice maker
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 11
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Displays do not illuminate.
The mains plug has not been inserted properly. Connect the mains plug.
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
The refrigeration unit is switching on more frequently and for longer.
The appliance was opened frequently. Do not open the appliance unnecessarily.
The ventilation openings are covered up. Remove obstacles.
Large quantities of fresh food have been put in. Switch on Super Freeze in good time.
Display indicates E….
Electronics have detected a fault. Call customer service.
~ "Customer service" on page 17
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on. Start the appliance self-test.
~ "Appliance self-test" on page 17
When the program has ended, the appliance switches over to normal
operation.
The ice maker is not functioning.
Ice cube production is switched off. Switch on ice cube production.
Freezer compartment is too warm. Set the temperature lower.~ "Operating the appliance" on page 11
Ice cube container is not properly inserted. Insert ice cube container fully.
Ice maker without power. Call customer service.
~ "Customer service" on page 17
No water supply. Check water connection and contact technician if necessary.
Low water pressure. Only connect appliance to pipes with sufficient water pressure.
Kink in water hose. Turn off water supply, straighten out kink. Replace water hose, if
necessary.