INSTALLATION INSTRUCTIONS For Built-in Microwave Ovens Oven Model MBB Built-In Trim Kits Models: MT27B MT30B (Sold Separately)
Please read this entire manual before proceeding IMPORTANT: Local codes vary. Installation, electrical connections, circuit breakers and grounding must comply with all applicable codes. Save these instructions for your local electrical inspector's use. INSTALLER: Please leave these Installation Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. WARNING: Disconnect power at the breaker before installing.
Step 1: Unpacking A. Microwave Oven Model MBB Open the box and carefully remove all fillers and packing material. Your new Thermador microwave includes the following: • Care & Use manual (1) • Quick Guide (1) • Warranty Card (1) • Turn Table (1) • Turn Table Support (1) B. Trim Kit Models MT27B & MT30B Open the box and carefully remove all fillers and packing materials.
Step 2: Cabinet Preparation It is a good practice when the microwave oven is installed at the end of a cabinet run, adjacent to a perpendicular wall or cabinet door, to allow at least 1/4" space between the side of the trim and wall or door. Width (B) MT30B MT27B 28-1/2" ± 1/16" 25-1/2" ± 1/16" Height (A) All Trim Kits 17" ± 1/16" Depth (C) All Trim Kits 24" ± 1/8" Outlet can be located anywhere within the shaded area as indicated in Figure 1.
Step 3: Electrical Installation The Thermador microwave oven is equipped with a grounded cord. The wall receptacle must be installed and grounded in accordance with the national electrical code. Also, electrical connections and grounding must comply with all applicable local codes. The electrical requirements for a separate circuit serving only this microwave oven are: 120V, 60Hz, 20Amps Step 4: Installing the Trim Kit Position the two vertical trim brackets using the template as shown on Figure 3.
Step 5: Installing The Microwave Oven Note: The four (4) ducts have a plastic covering that must be removed prior to installing them onto the microwave. 3. 4. WARNING 5. These ducts have sharp edges. Be careful when handling. 6. 2. Position the oven's four (4) cone-shaped legs on the base pan's four (4) large holes. Fasten with five (5) screws #8 x 1/4". Remove and retain Outer Case Screw at left side of the oven. 7. 8.
Step 5: Installing The Microwave Oven (continued) 9. Remove the left side vertical trim bracket (three screws) (MT27B only). 10. Slide the assembled microwave oven part way into the prepared cabinet cutout. Plug the electrical cord in the wall receptacle (ask for help from another person). Slide oven in the rest of the way into the cabinet. Position base pan on cabinet shelf with respect to the center line as shown on Figure 5. The front end of pan should align flush with the front edge of the shelf.
Thermador reserves the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649. For the most up-to-date critical installation dimensions by fax, use your fax handset and phone 702/833-3600. Use code #8030.