Installation instructions

Before you begin en-us
7
Before you begin
Before you begin
Before you begin
Read these instructions before you begin to install your
appliance.
Combination installations
For combination installations with other Thermador prod-
ucts (i.e. cooktop over oven, side-by-side ovens, etc.),
refer to the Approved Combination Guide located in the
manual set or on our website for additional clearance re-
quirements for your specific installation.
Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
8 x Oven mounting screws
(located in the red poly bag in the
broil pan package)
Refer to enclosed leaflet SCREW
INSTALLATION
Tools and parts needed
Prepare these tools and accessories before you start to
install your appliance.
¡ Pencil
¡ Measuring tape
¡ Level
¡ T-20 star bit screwdriver
¡ Cross head screwdriver
¡ Drill with bit 1/8"
¡ Knife
¡ Gloves
Power requirements and grounding
The outlet must be properly grounded in accordance
with all applicable codes.
Package removal
Package removal
Package removal
Protect any finished flooring before you move the oven.
Removing the packaging from built-in
single and double ovens
1. Cut the box straps.
2. Open the top of the carton and remove the top wood
frame.
3. Remove the carton by lifting it up and off the unit.
Alternatively you can carefully cut along the cut line
on the back left side of the carton with a blade
shorter than 3/4" (20mm).
4. Place the unit in front of the cabinet where it is to be
installed. The unit should be in line with the cabinet
cutout.
Leave the unit on the packaging base until it is ready
to be lifted into the cabinet cutout.
5. Remove all internal protective packaging, racks, ac-
cessories, and instruction manuals from the oven cav-
ity.
6. Remove the packaging brackets.
‒ With a T-20 star bit screwdriver, remove the screws
that go through the slotted holes in the mounting
brackets on the left and right side.
‒ Do not remove any additional screws from the
oven.
a The oven is released from the packaging base.
a The brackets remain in the packaging base.
7. Leave the appliance on the packaging base until you
lift it into the cabinet cutout or onto the lower oven.
Installation requirements
Installation requirements
Installation requirements
Read these instructions to prepare the installation space
for your appliance.
Appliance weight
The cabinet base must support the weight of your oven
as stated in this table.
Oven type Weight
30" Single oven 232lbs
(105kg)
30" Double oven 390lbs
(177kg)
Location requirements
Ensure your installation location fulfills the following re-
quirements before you begin with the installation proce-
dure.
¡ When an oven is installed at the end of a cabinet run,
adjacent to a perpendicular wall or a cabinet door, al-
low at least 1/4" (6.4mm) space between the side of
the oven and the wall or door.
¡ For oven support, install 2x4s extending front to back
flush with the bottom and the sides of the opening.
¡ The supporting base must be well secured to the floor
or cabinet and must be level.
¡ The cabinet opening must be plumb and the base
must be flat and level.
¡ When installing a side hinge oven, leave at least
10" (254mm) clearance to allow the door to open.
¡ Junction boxes can be located anywhere within reach
of the oven’s power cable.