Installation instructions

12
1. The unit and its bottom packaging (pallet) should be
positioned close to and in front of the cabinet opening
prior to beginning to lift the unit into place.
2. Lift or slide unit into the cabinet cutout without allowing
the unit base to contact the flooring.
3. Guide the unit straight back into the cabinet cutout.
Push the unit straight in until the oven trim is about
2 inches from being flush with cabinet wall. Be careful
not to crimp the flexible conduit between the oven and
the cabinet back wall. If necessary, guide the flexible
conduit into the wall or cabinet access hole so it
doesn’t prevent the unit from being pushed all the way
into the cabinet opening. The oven should be straight
and level, not crooked.
4. Push the unit all the way back into the cabinet cutout
until the front edge of the unit is flush with the front of
the cabinet.
5. Install the supplied screws through the tap holes in the
trim (2 screws for single ovens, 4 screws for double/
combo ovens). It is recommended to drill pilot holes
for the trim screws.
To ensure the door and oven function properly, the
screws should be installed on the face of the side trim
for traditional bottom hinge doors and on the side of
the side trim for side hinge doors.
6. Replace the oven door(s) according to the following
instructions.
Reinstalling Oven Doors with Bottom
Hinge
To replace the oven door:
1. Holding the door firmly in both hands, grip it on either
side. Do not grip by the handle.
2. Tilt the door back slightly towards you until it opens
about 7” at the top.
3. Slide the hinges into the slots as far as they will go and
then lower the door straight down. The angle of the
door may need to be adjusted slightly to allow the
hinges to engage properly and the door to lower into
place. The door should lower about 3/4” and stop. If
not, the hinges have not engaged properly and the
door could fall if it is released.
4. Lower the door into the fully open 90° position. If the
door will not lower all the way to the 90° position, the
hinges are not correctly seated. The door should be
straight, not crooked.
5. Push the levers on both the hinges up and forward
until they are locked into the slot, flush with the front of
the oven body.
6. Close the door gently. It should close all the way.
Gently open and close the door several times to be
sure it is correctly installed and securely in place.