INSTALLATION INSTRUCTIONS For Built - in Microwave Ovens Oven Model MBB Built-In Trim Kits Models: MET27B MET30B (Sold Separately)
Please read this entire manual before proceeding IMPORTANT : Local codes vary. Installation, electrical connections, circuit breakers and grounding must comply with all applicable codes. Save these instructions for your local electrical inspector's use. INSTALLER: Please leave these Installation Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. WARNING: Disconnect power at the breaker before installing.
Step 1: Unpacking A. Tools Needed: • • • • • • Caution: Tape Measure Drill with 1/16" bit Pliers # 2 Phillips Head Screwdriver Gloves Safety Goggles • Trim kits are designed for use only with the Thermador microwave oven models listed (See Table 1). • For safety, do not alter or modify any part of this kit or oven. • Unit is heavy and requires at least two people to lift or move. Microwave Oven Model MBB Remove and discard all packing material.
Step 2: Preparing the Cabinet The cabinet cutout dimensions are shown in Figure 1. • It is a good practice when the microwave oven is installed at the end of a cabinet run, adjacent to a perpendicular wall or cabinet door, to allow at least 1/2" (12.7 mm) space between the side of the trim and wall or door. • Your microwave oven can be installed into a cabinet or wall by itself or above any of the following Thermador wall ovens: C271, C301, CM301, S301, SC301.
Step 3: Preparing the Electric The Thermador microwave oven is equipped with a grounded cord. The wall receptacle must be installed and grounded in accordance with the national electrical code. It can be installed anywhere in the shaded area in Figure 1 (previous page). Electrical connections and grounding must comply with all applicable local codes. The electrical requirements for a separate circuit serving only this microwave oven are: 120V, 60Hz, 15Amp.
Step 5: Installing The Ducts 1. Remove and discard the protective plastic film from the 4 ducts. CAUTION The ducts have sharp edges. Be careful when handling. 2. 3. Set microwave upside down in stable location. 4. Attach base pan to bottom of microwave at leg holes. Fasten with two (2) 7/16" lag bolts. Install one bolt through front right leg hole and one through back left hole. Return microwave to right-side-up position. 2. Loosen the outer case screw near the vent on left side of the microwave. 3.
Step 6: Completing the Installation Caution: The microwave oven is heavy. Always use at least two people to lift the unit. 1. Lift oven into position and rest right rear corner in cabinet cutout. 2. Reach past microwave on left side to insert electrical cord into outlet. 3. Slide oven the rest of the way into the cabinet. Position microwave in cabinet so that base pan center hole aligns with cabinet centerline.
Thermador reserves the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649. For the most up-to-date critical installation dimensions by fax, use your fax handset and phone 702/833-3600. Use code #8030.
