® CARE AND USE FOR ISLAND HOODS (Turn Book Over for Installation Instructions) READ AND SAVE THESE INSTRUCTIONS HNI O O HTNI Model # Serial # 5551 McFadden Avenue, Huntington Beach, CA 92649 800/735-4328 RO#8605 35-05-274A ©BSH Home Appliance Corporation, 1998 Litho in U. S. A.
IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: CAUTION: FOR VENTILATION USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPOR. 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer (735-4328). 2. Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally.
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES AVERTISSEMENT - POUR RÉDUIRE LE RISQUE D’INCENDIE, DE CHOC ÉLECTRIQUE, OU DE LA BLESSURE AUX PERSONNES, OBSERVER LE SUIVANT: 5. Utiliser toujours les batteries de cuisine et les ustensiles appropriés pour le type et la quantité de la nourriture ayant préparée. ATTENTION: SEULEMENT POUR L’UTILISATION D’AÉRATION. NE PAS L’UTILISER POUR ÉPUISER LA VAPEUR OU LES MATIÈRES EXPLOSIVES OU DANGEREUSES.
CONTROL PANEL MODELS: HNI, HTNI ELECTRONIC TOUCH CONTROLS A. Motor OFF button B. ON button and motor speed selection button 1, 2, 3, 1,.... C. Speed 1LED D. Speed 2 LED E. Speed 3 LED F. Timer LED G. Timer. If the motor is off while the timer is pressed the motor will run at speed 3 for 20 minutes then stop. If the motor is running when the timer key is pressed the motor will continue to run for 10 minutes. After 10 minutes the motor will stop.
FILTERS CLEANING INSTRUCTIONS The metal grease filters are made of anodized aluminum and are long lasting. Be sure lights are cool before cleaning the hood. To Clean Filter/s It is recommended that the filters be washed at least once a month; they can be washed by hand or in the dishwasher. Drain water through holes and along filter edges and allow to dry thoroughly before replacing it. To Remove The Metal Grease Filter/s Turn blower and lights off.
LIGHTS NOTE: Turn blower and lights off. Make sure the lights are cool. If new lights do not operate: verify lights are inserted correctly before calling service. Replace Lights For Model HTNI (Fig. 3) Remove the damaged light and replace with a new halogen light Type MR16, 12 Volt, 20 Watt maximum. When installing the new light be sure that the two prongs of the light fit perfectly into the two sockets of the lightholder. Press in firmly. Fig. 3 Replace Lights For Model HNI (Fig.
Thermador Hood Warranty ® FULL ONE YEAR WARRANTY Covers one year from date of installation, or date of occupancy on a new, or previously unoccupied dwelling. Save your dated receipt or other evidence of installation/ occupancy date. Thermador Will Pay For: All repair labor and replacement parts found to be defective due to materials and workmanship. Service must be provided by a Factory Authorized Service Agency, during normal working hours. For a Service Agency nearest you, please call 800/735-4328.
Page 8
