installation instructions

Page. 16
IMPORTANT: DO NOT bend the broil burner orifice
bracket. Ensure that the broiler orifice is aligned to the
center of the burner tube inlet.
2. Label each of the removed orifices, noting from which
burner they were removed, in the event the appliance
is converted back to natural gas in the future.
For your convenience, note the orifice sizes and
locations in the following table.
3. Locate the proper burner orifices included with the kit.
Orifices are stamped with the orifice diameter size on
the side.
4. Replace orifices as indicated in the table. To avoid any
possible gas leak in this area, ensure the orifice is
completely seated and tight to the burner orifice
holding bracket and the 90° orifice elbow.
NOTE: The replacement broil orifices have straight
threads (not tapered threads) and DO NOT require thread
sealing compound.
5. Continue to “Removing and installing the oven
door(s), on GAS ranges only (PRG models)” before
reattaching the backguard assembly. Once all of the
broil and bake burners' orifices have been replaced
and converted to LP gas, reinstall the oven doors
before performing a gas leak check of all the replaced
bake and broil orifices and their associated supply
tube fittings.
Removing and installing the
oven door(s), on GAS ranges
only (PRG models)
9 CAUTION
• USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY.
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure
to do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both
hands to remove or replace the door.
• Failure to grasp the oven door firmly and properly
could result in personal injury and product
damage.
• With the door off, never release the levers and try
to close the hinges. Without the weight of the
door, the powerful springs will snap the hinges
closed with great force.
To gain access to the bake burner orifices, you will need to
remove the oven door, kick panel, and the bottom front
panel, if applicable.
Removing the oven door
1. Open the door fully. Flip the hinge clips down for both
sides of the door. A screwdriver may be required to
carefully pry the clip back.
2. Close the door gently until it stops against the hinge
clips. The open hinge clips will hold the door open at
a slight angle, about 30°, from the closed position.
Main oven broil Aux oven broil
Description Main oven broil Aux oven broil
Pro Grand 1.25 mm (125) 0.813 mm (813) or “67”
Pro Harmony 1.25 mm (125) 0.75 mm (75)