Installation Sheet

ManualsBrandsThermador ManualsAccessoriesThermador LP Conversion Kit for Dual Fuel Pro Harmony and Rangetop

Page. 10

High Altitude Adjustment Instructions and

Setting Valve Screws for LP Converted Burners

High Altitude

This appliance has been tested for operation up to an

altitude of 10,100 ft (3078 m) elevation above sea level.

For altitudes above 2,000 feet (610 m) elevation above sea

level, adjustments can be made with the High Altitude

Packet. If flame performance is satisfactory, the contents

in this packet will not be required. It is required that a

Certified Professional make the high altitude adjustments

during installation.

Propane (LP) Gas Appliances – If the appliance is to be

adjusted for high altitude and also converted to Propane

(LP) gas, the appliance must first be converted for use with

LP before it can be adjusted for use at high altitude.

Setting Valve Screws

1. SHUT OFF THE GAS SUPPLY TO THE APPLIANCE.

2. DISCONNECT THE ELECTRICAL POWER.

3. Remove knob from the valve stem by slowly pulling

knob straight out, away from the control panel.

5. To engage the valve screw, insert the included flat-

blade screwdriver with 1/8'' blade into the hole in the

bezel created by removal of the mounting screw.

Access to the valve screws through clearance hole in

the spark module. You should feel the engagement of

the screwdriver and the valve screw.

6. FOR STANDARD BURNERS, adjust the valve screw by

turning the valve screw clockwise about an

1/8 turn. Adjust the valve screw as little as required to

reach satisfactory simmer results. Due to normal

fluctuations in gas pressure, over-adjustment of valve

screw may affect flame stability.

FOR EXTRALOW BURNERS, auto-cycling of the

XLOW burners allows for exceptional simmer results

and adjustment is not required. However, adjustment

to the valve screw may be performed to suit individual

preference.

A flat-head screwdriver with an

1/8" [3.0 mm] wide, .020"

[0.50 mm] thickness tip

(included) is used to reposition

the valve screws for minimum

flow settings on manual valves.

4. Remove the bezel-mounting

screw located to the right of

the valve stem, using a T-20

Torx driver.