Installation Instruction

Page. 22
• It may be necessary to reposition the gas supply
line and the electrical cord as the range is pushed
back to its final position. This may be
accomplished by carefully pulling on a rope or
twine looped around the gas or electrical supply
line as the range is pushed back into its final
installed position.
3. As the range is moved into its final, installed position,
verify that the anti-tip bracket is in a position to
engage the range.
Adjusting the kick panel
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall the Torx screw.
3. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½'' (12.7 mm) clearance above the floor.
Data rating label
Data rating label
The data rating label shows the model and serial number
of your appliance. The label can be accessed by first
removing the kick panel, as shown below.
Electric wiring diagrams and schematics
The electric wiring diagrams and schematics are attached
behind the toe kick, and should not be removed except by
a service technician, then replaced after service.
Burner test
9 WARNING
To prevent flare-ups and avoid the creation of harmful
by-products, do not use the cooktop without all
burner caps and all burner grates properly positioned.
9 WARNING
To prevent burns, do not touch burner caps or grates
while hot. Turn the cooktop off and allow the burners
to cool.
Install any loose components, such as burner caps and
grates that may have been removed earlier. Be certain that
burner caps seat properly into the burner bases. Before
testing operation of the appliance, verify that the unit and
the gas supply have been carefully checked for leaks and
that the unit has been connected to the electrical power
supply. Turn the manual gas shut-off valve to the open
position.
1/16''-1/8''
(2-3)
inches (mm)