Installation Instructions

Page. 20
3. Align the back panel of the new accessory with the
flanges on the range side panel’s right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard’s front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.
Door removal and adjustment
9 CAUTION
• USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY.
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure
to do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both
hands to remove or replace the door.
• Failure to grasp the oven door firmly and properly
could result in personal injury and product
damage.
• With the door off, never release the levers and try
to close the hinges. Without the weight of the
door, the powerful springs will snap the hinges
closed with great force.
To remove the oven door
1. Be sure to read the above CAUTION before
attempting to remove the door.
2. Open the door fully.
3. Flip the hinge clips for both sides of the door. A
screwdriver may be required to carefully pry the clip.
4. Close the door gently until it stops against the hinge
clips. The open hinge clips will hold the door open at
a slight angle, about 30°, from the closed position.