Installation Instructions

Page. 5
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
REAR CLEARANCE REQUIREMENTS:
• To avoid staining on the back wall, high temperature,
non-porous construction materials suitable for use in a
cooking environment are recommended.
• Models PCG305xx, PRG305xx, PRG304xx, PRD305xx,
PRD304, and PRD606xx are suitable for 0'' rear
clearance to combustible surfaces.
• All other models:
• When using the included island trim a minimum 6"
(152 mm)* rear clearance is required to a
combustible surface*.
• When installing against a combustible surface, a
Thermador
®
low backguard is required for a 0''
rear clearance to the combustible surface. A
Thermador Low Backguard must be purchased
separately.
• A rear clearance to a surface covered in a non-
combustible material (metal, ceramic tile, brick,
marble, or stone)
*
is 0" when using the included
Island Trim.
*Clearances of less than 6'' (152 mm) should be approved by the
local codes and/or by the local authority having jurisdiction.
 Clearances from non-combustible materials are not part of the
ANSI Z21.1 scope and are not certified by CSA.
WARNING
To avoid possible burn or fire hazard, a backguard
designed specifically for this appliance should be
installed whenever the appliance is used.
WARNING
To eliminate risk of burns or fire caused by reaching
over heated surface units, cabinet storage located
above the surface units should be avoided.
CAUTION
This unit is designed as a cooking appliance. Based on
safety considerations, never use it for warming or
heating a room. Doing so may result in carbon
monoxide poisoning and overheating the appliance.