Installation guide

a. b. c.

C3 Manually insert the screw into the walt plug until the

screw begins to resist.

C3 Knock the walt plug and screw into the hole until the

screw head is approx. 1/2"(13 mm) from the anti tip

bracket.

C3 Tighten the screw.

6. Attaching an alternative anti-tip

device

If possible, always screw the wooden beam to

existing studs on the rear panel of the cavity.

If the anti tip brackets cannot be attached securely,

an alternative anti tip device can be attached.

However, ensure that there is no play between the

appliance and the anti tip device.

[3 Saw the wooden beam (cross section min. 3" x 4")

to the required length.

Length is equal to the width of the installation cavity!

[_ Note

If the installation cavity is deeper than the appliance,

select a beam which has a larger cross section or

attach 2 beams.

The beam must cover the appliance by at least 2"

(50.8 mm).

[3 Mark the installation height (lower edge of the beam)

on the rear panel of the cavity.

C3 Select screws according to the thickness of the

wooden beam: length - min. 2.5 x beam thickness,

diameter #12 or #14.

Specify the number of screws according to the

cavity width, thereby ensuring that the beam can

be attached securely.

Locate watt studs near the rear panel of the cavity

and mark drill holes in the beam.

Predritt the wooden beam.

Attach the wooden beam to the rear panel of the

cavity.