Installation guide

The height adjustable feet at the front and rear can all
be adjusted from the front.
Front: with open ended wrench 1/2" (SW13)
Rear: with 5/1¢" (8 mm) hex nut driver
via flexible shaft.
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting
the height, align this mark at a height of 1_A"(32 mm)
above the floor.
12.
C3
Attaching the appliance to the
top of the cavity
Screw the attachment plate tugs (top) to the
overhead furniture/fixtures.
[3 Unscrew the height adjustable feet until the mark
on the base has reached the indicated guide
dimension (11/4"/ 32 mm).
[_lt is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
C3 Align the furniture fronts with the spirit level.
_i] Note:
Do not twist or jam the appliance inside the cavity!
When unscrewing the height adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
If using a wooden beam as an alternative anti tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards
the wooden beam.
[3 Fix the attachment plate side tugs (top) depending
on the installation situation. If there is no gap or only
a slight gap, it is not necessary to fix the side tugs.
C3 If there is a fairly large gap above the appliance, fit a
wooden beam above the appliance, ensuring that
the wooden beam fits the gap exactly.
22