Installation guide

E3 Pull out the brackets by the measured amount Y.

C3 Screwthe brackets tightly.

16. Preparing the furniture doors

When performing any work on the furniture doors,

always observe the following:

Always screw into the best toad bearing material

of the furniture door.

Select a screw length which is always shorter than

the thickness of the furniture front.

To prevent damage, protect surfaces of the

furniture doors during installation.

The total weight of the furniture front must not

exceed the following values:

1 8"

24"

30"

BM 36" (top, 1 door)

BM 36" (top, 2 doors)

BM 36" (bottom)

37 tbs / 17 kg

50 tbs / 23 kg

64 Ibs / 29 kg

55 tbs / 25 kg

26 tbs / 12 kg (per door)

22 tbs / 10 kg

The furniture fronts are attached to the appliance door

by means of fitting parts on the appliance. These fitting

parts allow the furniture door to be adjusted precisely

and attached securely to the appliance.

C3 Attach the base panel.

_T]lf required, the toe kick panel can be screwed to the

base panel. There are screw holes in the base panel

near the Vetcro.