Installation guide

18. Attaching the adjusting rail

to the furniture door

[_The adjusting rail is the most important means of

adjusting the furniture front.

C3 Unscrew the installation support part from the

appliance door.

[_ Check the double threaded bolts on the adjusting

rail. Both of them must project out of the door by

3/16" (5 mm).

4X15

C3 Mark this amount X on the rear of the furniture door.

C3 Determine and mark the centre of the furniture door.

C3 Loosen the 2 nuts and remove the adjusting rail.

C3 Put on the adjusting rail and align along the marks.

Mark the drill holes.

C3 Drill the holes.

C3 Screw on the adjusting rail tightly.

[_ Note

Attach the adjusting rail to the furniture door with at

least 6 screws. One screw should be inserted under

each double threaded bolt.

18" _ 6x

4 _

30"

lOx

Measure the distance X between the adjusting rail

and the overhead furniture/fixtures.

The adjusting rail features a variety of holes for the

many different design options of furniture doors.

Always screw into the best toad bearing material

of the furniture door.