Instructions for Use

Page | 12
Excessively warm environment.
Avoid placing the unit in direct sunlight, or near
a heat source. If the appliance is in an unusually
warm environment, the compressor will run
more.
Door gasket is not sealing.
Inspect the condition of the gasket. If
damaged, cold air can escape the cabinet
and cause the compressor to run more than
normal.
Products and beverages in the unit are
too cold.
Temperature has been set too low.
Increase the temperature. See “Setting the
temperature”.
Product placed too close to ventilation
holes.
Rearrange the bottles, so that nothing
obstructs the interior ventilation holes.
The interior light (LED) does not work.
The unit is set to Sabbath mode.
Disengage Sabbath mode. See
“Getting to know your appliance” section.
There are unpleasant odors coming from
the appliance.
Some bottles may not be correctly
closed or the content of some bottle
may be spilled.
Clean the appliance. Be sure all the bottles
are correctly closed.
(See chapter “Odors”).
Hi-alarm is activated (due to high
temperature inside the appliance), HI is
shown on the display LED.
Appliance opened frequently.
Do not open the appliance unnecessarily.
Press alarm once to deactivate.
The ventilation openings have been
covered.
Remove obstacles at the ventilation
openings located at the base of the unit
and in the refrigerator interiors. Press
alarm once to deactivate.
A large amount of product, or warm
product was placed into the appliance.
Wait until the products cool off or
remove the warm products from the
appliance, then press alarm once to
deactivate.
Excessively warm environment.
Avoid placing the unit in direct sunlight, or
near a heat source.
Press alarm once to
deactivate
Door gasket is not sealing.
Inspect the condition of the gasket. If
damaged, cold air can escape the
cabinet and cause the temperature to
rise. Press alarm once to deactivate.