Instructions for Use

Page |
9
Controlling the cabinet lighting
The interior cabinet light settings can be controlled using
the LIGHT button on the CONTROL
PANEL. The
luminosity level will increase by one
unit (displayed
as
one LED light over the LIGHT button) every time the
button is pressed. When the level is already in “High” (3
LED lite), the next press will reset the level to “None”
and no LED light will be displayed. When the door is
opened, the interior light will automatically illuminate to
its maximum intensity (High level) independently of the
setting on the
control.
When
the door is closed, the interior light will adjust back
to the setting indicated above the LIGHT button as per
following table:
LIGHT setting
Closed-Door
Cabinet Light Level
None
Low
Medium
High
(same level as
when
door is
opened)
If the LIGHT preset is “None”, the interior lights will turn
on only when the door is open and will dim off again when
the door is closed. These light level settings can be used
to conveniently display the contents of the Wine Reserve
even when the door is closed.
The factory default for closed-door light level setting is
“High”.
• Press the LIGHT button repeatedly to cycle between
The level settings.
• The interior lighting will temporarily adjust to the
selected setting for a few seconds. This provides a
visual sample of the selected level, before returning to
the open-door (maximum) lighting level.
Toe-Kick
The Toe-Kick itself can be removed for service or
cleaning (see “Cleaning behind the Toe-Kick” in the
next section).
1. Remove the stainless steel Toe-Kick by unscrewing
and removing the two front screws with a Philips
screwdriver.
Front
screws
2. You can remove the Toe-Kick by simply pulling it out.
3. To reattach the Toe-Kick, align the holes with the
support tab and screw the frontal screws in the same
position with a Philips screwdriver.
NOTE: Removal of the kickplate is not encouraged, but
if necessary, it is recommended to be done by an
authorized service personnel.
Cleaning the appliance
WARNING:
Never clean the appliance with a steam cleaner!
CAUTION:
• Do not use abrasive or acidic cleaning agents and
solvents.
• Do not use scouring or abrasive sponges. The
metallic surfaces could corrode.