User Manual

HR-07-Trio-Type L

Heatsink

HR-07-Trio-Type L

Heatsink

HR-07-Trio-Type L Heatsink

0.5mm

Thermalpad

0.5mm Thermalpad

Memory Module

Memory Module Slot

Step 1 : Thermal Pad Backing Tear Off

Take out the Thermal pads from the accessory pack and

peel off the protective film.

Step 2 : Thermal pad Application

Apply the adhesive side of the thermal pad to the memory

module on each side.

Step 3 : Heatsink Installation

After carefully inserting the memory module into the clamps

of HR-07-TRIO Type L, stick the Memory Module with the

heatsink attached into the memory slot as depicted in the

illustration.

Step 4 : For Single Slot Memory Setup

Once you have installed a HR-07-TRIO Type L on your

memory module, you are basically done. If you plan on

installing more memory modules, please go on to the next

step.

Step5: HR-07-TRIO Type L For a tri-channel

DDR3 Setup

For a tri-channel setup, please repeat step 1 to step 4 for

each of the three memory modules.

Step6: For a Full Six Slot DDR3 Setup

To install on all six slots, you will need to have a set of

HR-07-TRIO Type H and a set of HR-07-TRIO Type L.

Install as depicted in the illustration.

PAGE 1
HR-07-Trio-Type L Heatsink Step 1 : Thermal Pad Backing Tear Off Take out the Thermal pads from the accessory pack and peel off the protective film. HR-07-Trio-Type L Heatsink Step 2 : Thermal pad Application Apply the adhesive side of the thermal pad to the memory module on each side. Step 3 : Heatsink Installation After carefully inserting the memory module into the clamps of HR-07-TRIO Type L, stick the Memory Module with the heatsink attached into the memory slot as depicted in the illustration.