Installation guide

www.thermalright.com

(pic. 3)

blue rubber

strips

(pic. 2)

XP-90 parts list

Parts List

HSF Body with 2 mounting clips

White Rubber vibration damper strips

80 mm fan wire clips

90 / 92 mm fan wire clips

Thermal paste in syringe

K8 Adaptive RM

M3 15mm screws

Quantity

K8 installation for XP-90

1. Remove stock RM by unscrew both Philip screws and drip

a couple drops of nail polish remover on the sides of RM to

unglue it from the motherboard, this way RM can be easily

removed without damage PCB and components.

2. Put a thin, even layer of thermal grease on both CPU IHS

and HSF base.

3. Place the included K8 Adapting RM around CPU and use

enclosed M3 15mm screws 8A/B to secure the adapting

RM into stock backplate.

4. Hook the retention hooks 5/6 A into K8 Adapting RM holes

7 A/B, use them as leverage point and gently push HSF

down into RM. Hold the HSF down.

5. Use a small flat screw driver, and hook 5/6 B into RM holes

7 C/D. Slightly rotate the HSF for optimal contact with

CPU IHS.

6. Hook fan wire clip 2 C/D into holes 4A/B, do the same with

fan clip 3C/D to 4C/D. (pic. 2)

7. Put enclosed white rubber strips on the side of HSF fins to

damper the fan vibration. (pic. 3)

8. Place the 80/90/92 mm fan of your choice on top rubber

strips over the Heatsink fins. Hook fan wire clips 2A/B to

lower fan casing screw holes 1A/B, 3 A/B to lower fan

casing screw holes 1C/D.

XP-90

Installation Guide

XP-90

Installation Guide

Top View

Side View