Installation Guide

81161 4 OF 6 REV B 01/15 JWJ
WARNING: Make sure there is no insulation or combustible material within 8 inches of The
transformer. NO material should touch the transformer.
 Use the proper Crimping tool for solderless connectors: WT1455, WT2000, WT105M,
ERG-2001, ERG-2003.
4. You will need to supply 18-gauge wire to connect and extend blue and red transformer wires. Pull the
wires through the hole, leaving roughly 1.5 feet extra out from wall for maneuverability and ease of
installation.
5. Connect the mirror to the transformer by crimping the two wires from the mirror (with solder-less
connections on ends) to the two transformer wires now coming through the 5/8” drill hole.
6. Cover the plug located on the wires from the mirror with silicone and gently push the wires and
crimped connections into the 5/8” hole and insert the plug into hole, sealing the hole with silicon while
mounting mirror.
7. Transformer is to be mounted in remote location. Make sure mounting location is a dry well ventilated
space. DO NOT MOUNT IN SHOWER.
8. To reduce the risk of fire do not store or use in the vicinity of flammable liquids or vapors.
Figure #3
Figure #2