Installation Sheet
92027-390_A 7/17
TFXM-390
FX SERIES Manual Flush Steam Generator
Rough-In Guide
Shipping Information:
Weight………………… 25 lbs.
Length………………..…21 in.
Width……………....….10.5 in.
Height………….…..…..14 in.
FX Series Manual Flush Steam Generator
SPECIFICATIONS
Input Voltage………….……......208-240VAC Single Phase
Kilowatt Rating………………………………………..…..11.0
Maximum Amperage…………………………..…....55 AMPS
Breaker Size……………………………………....….60 AMPS
Water Inlet…………………………….…...3/8” Compression
Steam Outlet…………………………………….…….1/2” NPT
Safety Valve………………………………………..….3/4” NPT
Electrical Connection………………………….....Hardwired
Maximum Room Size (Cubic Feet)………..………..…...395
For any further assistance please contact ThermaSol at
800.776.0711 or sales@thermasol.com
• Can be plumbed up to 50 ft. from the steam room
without upsizing the generator
• Stainless steel construction throughout
• Temp Sensor is built into controller
Installation Notes:
Generator must be installed by a licensed electrician.
Install this generator according to the installation guide supplied. Follow all local plumbing and electrical codes. Unit must be accessible for
service and maintenance. Generator is factory sized: L x W x H = Steam Room Cubic Feet = 395 Cu. Ft. max. Choose the appropriate generator.
For every additional foot of ceiling height over 8 ft, use the next larger generator. Always round up when calculating the total cubic feet.
Product Specification Basics:
The steam generator unit dimensions are approximately 17-3/4”L x
6-1/8”W x 12-3/4”H in dimension. The generator shall be made from
stainless steel.
FX Series Manual Flush Series Standard Equipment:
• Manually Operated PowerFlush – Pressurized inner tank cleaning system
• Includes Fast Start – Steam in seconds… not minutes
• Constant Steam at a constant rate
• Unit has 208-240 volt power connections to be installed by your licensed
electrician
• Superior heating element – low watt density