Installation Sheet

Connecting Cables

Mounting Hardware

Connecting Water Supply

• Connect the 3 1/2” x 1/4” all-thread rod bolts (studs) together with

supplied couplings.

• Insert the 3 1/2” x 1/4” studs from the shower side into the 7/16” pre-

drilled holes. Hold it in place while from the top side of the cut out insert

supplied spring, washer and secure it with provided wing nut.

• Tighten retaining spring to half its normal height (shown on page 14)

Repeat the above steps for all three studs

NOTE: Make sure to ush out any debris from the pipe before

connecting the xture!

You will need a 36” ex water supply that connects to your water pipe

that you plumbed for the Rain Head. The connection to the Rain Head

needs to be 3/8” compression. Please connect the 36” ex water

supply from the water source to the Rain Head. Do NOT over tighten.

Slowly open the water and check for leaks before proceeding.

Flex Water Supply

Connect the Audio cable that is connected to the

ThermaTouch control.

• Red to (R), White to (L), and make sure that both cables are

connected to the same Input “1” or Input “2”.

• At this point IF you have any other audio source to be connected

please do it now to the open Input on the Rain Head.

• Next, connect the M12 power/data cable that runs or will run to the

Power Distribution Module (PDM).

NOTE: Make sure that the “L” shaped end of M12 cable is

connected to the Rain Head

Audio Cable

from ThermaTouch

control

M12 power/data

cable to PDM

Total Wellness Package

1616

THERMASOL.COM

800.776.0711