Wellness Steam Package Installation Manual For Tutorials and Troubleshooting visit www.thermasol.
SignaTouch Control Installation Manual For Tutorials and Troubleshooting visit www.thermasol.
Wellness Steam Package 1 Important Information before You Install The SignaTouch Control must be installed inside the shower. The ThermaTouch control will only function on the current TFX, SSA and PRO Series generators. The control should be installed 60" from the floor of the shower and away from the steamhead. The steamhead should be installed 24" from the floor and 6" from any wall. Locate as far as possible from the bathing seating area or location of the users and not below any fixtures.
Wellness Steam Package 2 Tools and Materials Back of Control Power/Data M8 connection Controller Item STCX-XXX Silicone Mud Ring Item 04-8566 Installation instructions, warranty, static cling warning label Materials needed: o SignaTouch control o M8 cable o Silicone o Mud Ring o Other materials as required 3 Mud Ring Application Top Horizontal Installation Top Vertical Installation Shower wall Mud Ring goes inside wall opening Shower wall 5.7" W by 3.
Wellness Steam Package 4 Control Installation and Data Cable Connection Installation with generator only Route the M8 cable through the finished wall to the back side of the control. (The other end of the cable runs to the steam generator location.) NOTE: It is recommended to run the cable through electrical conduit. DO NOT STAPLE the cable! Shower wall M8 Cable Installation with one of or all, SLSR, Digital shower valve, and steam generator.
Wellness Steam Package 5 Sealing Control THESE STEPS MUST BE TAKEN FOR CORRECT INSTALLATION OF THE CONTROL. REMOVE MUD RING FROM WALL CUTOUT BEFORE MAKING FINAL CABLE CONNECTIONS TO THE THERMATOUCH CONTROL. TEST THAT ALL CONNECTIONS ARE WORKING BEFORE SEALING THE CONTROL TO THE WALL. (Power on the control and see that it lights up). A Coat the entire edge of the control with supplied waterproof silicone to fully seal the control to the wall.
Wellness Steam Package 6a Connecting SignaTouch to the Generator M8 Cable 6b Connecting SignaTouch to Serenity Light, Sound, Rainhead (if applicable) M12 Cable 110v M8 Cable THERMASOL.COM I 800.776.
Wellness Steam Package 6c Connecting SignaTouch to Digital Shower 110v M12 Cable M8 Cable 6d Connecting Total Wellness Package 110v M12 Cable M8 Cable M8 Cable 8 THERMASOL.COM I 800.776.
Wellness Steam Package 7 Steam Line and Steamhead Now you will need to decide on the steamhead placement in the shower so you can run the steam line from the generator to the steamhead. There are a couple of things you need to know about the placement of the steamhead and steam line itself. DO NOT install any valve in the steam line. Flow of steam must be unobstructed. The steam line can run up and then down, once; or horizontal; but never run down and then up.
Wellness Steam Package Steamhead Location DO NOT install the steamhead near the seating area or the user. DO NOT forget to install the steamhead rough-in fitting! C I nstall the steamhead 24" from the floor or bathtub rim and 6" from any corner. Steamhead is to be mounted as far as possible from typical bathing position (seated or standing) and installed as far from the in-shower controller as possible.
Wellness Steam Package D Once the shower wall is complete and the housing is sealed to the wall, remove the protective cap and insert the steamhead into housing. Use the supplied silicone to adherethe steamhead to the wall sealing out any water from getting behind the head. Use supplied o-ring lubricant to assist in steam head installation. A very small amount is all that is need directly on the o-rings.
Serenity Light, Sound, Rain Head Installation Manual For Tutorials and Troubleshooting visit www.thermasol.
Wellness Steam Package 1 Important Information Before You Install PLEASE REVIEW WARNINGS BELOW AND LEAVE THIS MANUAL WITH HOMEOWNER DO NOT USE THIS PRODUCT UNLESS YOU HAVE CONSULTED WITH YOUR DOCTOR AND RECEIVED WRITTEN PERMISSION TO DO SO. USE OF THIS PRODUCT MAY BE HAZARDOUS TO YOUR HEALTH. PLEASE CONSULT YOUR PHYSICIAN BEFORE USING. IF YOU ARE PREGNANT, ELDERLY, HAVE HIGH BLOOD PRESSURE, DIABETES, SUFFERING FROM HEART DISEASE, ARE INTOXICATED, OR NOT IN GOOD HEALTH, DO NOT USE THIS STEAM BATH.
Wellness Steam Package 2 Tools and Materials Parts Enclosed: Serenity Light, Sound, Rain Head fixture and hardware Item SLSRX-XX Silicone 25-foot Yellow M12 Cable Item 03-7149-25 Bluetooth Module Installation instructions Compatable controls: Materials needed: o Tile Cutter ThermaTouch 7" and 10" o PDM (Item 10-8147) o Ply Wood Backing Board SignaTouch Control o Compatible controller o 36" long 3/8" Compression Flexible Water Line Signature Control o Drill o Separate water vo
Wellness Steam Package 3 Placing and Cutting Template After completing the shower construction and running the necessary cables, water supplies and etc. using template included in these instructions (page 8) proceed to: Cutout • After choosing the desired location, use the printed template to drill the three 7/16” holes • Then proceed cutting the cutout 7/16” Note: Template must be printed out at actual size. Install suitable wood support between joists.
Wellness Steam Package 4 Mounting Hardware • Connect the 3 1/2” x 1/4” all-thread rod bolts (studs) together with supplied couplings. • Insert the 3 1/2” x 1/4” studs from the shower side into the 7/16” predrilled holes. Hold it in place while from the top side of the cut out insert supplied spring, washer and secure it with provided wing nut.
Wellness Steam Package • Carefully conceal in attic space any extra lengths of the cables or the water supply above the shower area. Align the Rain Head fixture to the three couplings. Make sure that the Rain Head will fit perfectly and flush with the ceiling. IF needed please adjust the studs and couplings to assure perfect fit.
Wellness Steam Package 1 2 3 4 5 6 7 Template must be full scale 1:1 when printed 1 2 3 4 18 5 5 6 7
Wellness Steam Package ThermaSol Product Registration Dear ThermaSol End User: Please register your product at www.thermasol.com/warranty so we can assist you much quicker if you ever need to contact our Technical Support Department. In addition we’ll keep you informed about your product and time to time we’ll update you about new products and other company announcements. Thank you from all of us at ThermaSol and we wish you many relaxing and steamy days ahead.
1958 STEAM WAY ROUND ROCK, TX 78665 PHONE: 800.776.0711 | FAX: 800.556.5257 | WWW.THERMASOL.