CP3 Professional Hot Water Extraction Cleaning System Owner/ Operator Manual Products for a Healthier Indoor Environment thermaxaf.
Table of Contents Message from the Corporate Office....................................................................... 2 Identifying Features................................................................................................ 3 Inspection Upon Delivery........................................................................................ 4 Important Safety Information.................................................................................. 4 Set-Up Procedure........................
Message from the Corporate Office Congratulations on the purchase of your new Thermax CP3 Professional Hot Water Extraction Cleaning System! In 1971, Thermax founder Carl Parise developed the world’s first UL approved carpet steam cleaner for the U.S. market, and has since produced over 500,000 units sold worldwide. We have adopted our own brand name, Thermax, which is rapidly becoming a household name, synonymous with the industry.
Identifying Features 11 4 2 8 1 7 3 9 6 10 1) Clean Solution Tank 2) Stationary Lid with Solution Tank Fill Hole 3) Recovery Waste Tank 4) Recovery Tank Dome and Vacuum Seal 5) Power Cord 6) Brass Female Quick Connect Coupling for the Solution Hose 7) Auxiliary Female Outlet for the Optional Power Brush 8) Vacuum Inlet/Vacuum Hose Connector 9) Pump/Heater Switch 10) Vacuum Switch 11) Easy Pull Handle 3 5
Inspection Upon Delivery Carefully unpack and inspect the Thermax CP3 and be sure all components ordered are included. Orders might be packed in more than one box. NOTE: Contact the carrier immediately regarding any damage incurred during shipping as it is your responsibility to file a damage claim with the carrier.
Set-Up Procedure 1) Pre-mix cleaning solution as required for specific application in a five gallon (19 liter) pail. Pour pre-mixed solution through solution fill hole of system (page 3, #2). NOTE: This system has a built-in solution heat maintenance feature, start with hot water if possible. Hot water is hygienic and maximizes cleaning potential. 2) Add appropriate amount of defoamer to the recovery tank (page 3, #3). 3) Connect end of the vacuum hose to the vacuum inlet connector (page 3, #8).
System Clean-Up When the carpet cleaning process is complete, it’s time to clean the system. De-activate all switches to “OFF” position. 1) Empty and rinse recovery tank. 2) Empty solution tank. a. To empty solution tank of unused solution, turn vacuum switch to “ON” position. b.
Optional Packages & Accessories The following optional packages and accessories do not come standard with your CP3. Contact your local distributor or the Corporate Office to receive details on how to purchase these items.
Optional Accessories Continued 1 2 15’ Hide-A-Hose w/ Built-On SS Details Part # U1570-15-CP5 Easy-Pull Handle w/Hardware PVC HAndle w/Hardware, Part # CP3-Han-ASSY 1) PVC Handle, Part # CP3-Han 2) Hardware, Part # CP3-Han-HDW Double Unit Header sign Part # f-hs-2umr Single Unit Header sign Part # f-hs-1umr 1 2 Single Unit Rental RAck, Metal Part # 32-502-01 Double Unit Rental RAck, Metal Part # 32-502-02 8 Outside Frame w/Insert Sign 1) Frame: Part # WORS-F 2) Sign: Part # WORS-I
Profits! Profits! Profits! Offer your customers Also Offer The Breeze® Water Based Air Purifier Double Unit Single Unit Call for information on how to receive an exclusive territory for setting up Thermax Rental Centers at retail locations in your area.
Steam Cleaning Solutions Air Purifiers and Solutions Nearly thirty-five years of extensive field use and refinement have proven our safe and effective cleaning solution formulas. Thermax has a product for just about every carpet cleaning application. Formulated specifically to be used in conjunction with Thermax AF2 carpet cleaning systems the products and their application are further defined below. LIQUID CARPET & UPHOLSTERY CLEANER (6060-I): (16 or 32oz.
Thermax CP3 Specifications Dimensions: • Length . . . . . . . . . . . . . . . 28” • Width . . . . . . . . . . . . . . . . 17” • Height . . . . . . . . . . . . . . . 26” • Weight . . . . . . . . . . . . . 39 lbs. Recovery Tank: • Hygienic Stainless Steel • 3 U.S. Gallons Solution Tank: • Hygienic Stainless Steel • 3 U.S. Gallons • 300 Watt Heating Element Electrical: • 115 Volt AC • 11.5 AMP • 50/60 HZ • CE Vacuum Motor: • 2-Stage By-Pass • 112” Water Lift Pump: • 60 P.S.I.
Troubleshooting Condition Cause Correction System Will Not Operate 1) Plugged into dead outlet 2) Blown fuse or breaker 3) Defective power cord 4) Defective switch 5) Loose wiring 6) Improper connection 1) Plug into live grounded outlet 2) Replace fuse or breaker 3) Replace power cord 4) Replace switch 5) Properly connect wiring 6) Press tightly into outlet Vacuum Motor Will Not Run 1) Main power not activated 2) Loose wiring 3) Defective vacuum switch 4) Defective vacuum motor 1) Active main power
Thermax CP3 Schematic 13
Thermax CP3 Parts List ITEM NO. 1 2 3 4 5 6 6A 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 THERMAX NO.
Floor Wand Schematic 15
Floor Wand Parts List ITEM NO. THERMAX NO. DESCRIPTION 1 04-028-01 Screw, 10-32 x 1”, PH, PHIL, Zinc 2 04-321-00 Nut, 10-32, Nylock 3 28-181-000 Assy. Upper Wand w/Cuff 4 01-315-00 Cuff, W/o Release, Gray, PB309 5 28-182-000 Assy, Lower wand w/cuff 6 01-316-00 Cuff, W/Release, Gray, PB309 7 28-203-125 Assy, Wet HD w/wear Plate 8 04-001-02 Screw, 4-40 x 1/4 9 03-450-01 Nozzle, K2.5 10 04-352-01 Clamp, .5”, Yellow 11 05-016-00 Hose, .
Upholstery Wand Schematic 17
Upholstery Wand PArts list ITEM NO. THERMAX NO. DESCRIPTION 1 04-457-06 Male Disconnect 1/4 Ftp 2 04-002-00 Screw, 3/8 - 24 X 3/8 Socket Set 3 04-161-00 Hose Assembly 4 29-561-0001 Assy, Valve, Brass, w/Handle HW 5 03-466-01 Hose Barb 3/16 X 1/8 MPT 6 35-273-000 Assy, Steam Head, 4” X 1.25” W/Plate 7 04-359-00 Clamp, Hose, .437, Single EAr 8 05-019-00 Hose, 3187, Braided Vinyl Price/Foot See your local distributor for any other items, solutions, and spare parts or visit thermaxaf.
Power Brush Schematic 19
Power Brush Parts List ITEM NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 THERMAX NO. 04-028-01 04-323-00 04-321-01 04-364-00 04-005-00 28-307-015 01-315-00 28-308-00 01-316-00 28-203-900 04-322-00 03-060 04-001-02 03-450-01 04-352-01 05-016-00 04-353-00 04-552-00 29-561-000 03-459-00 03-457-01 04-303-00 04-273-20 04-380-03 30-055-120 37-001-001 40-0770012 03-067-01 DESCRIPTION SCREW, 10-32X1”.
Additional Commercial Units Also available to make your job easier, the Thermax CP5 or the DV12 gives you the power and efficiency to clean carpets and upholstery in both commercial and residential settings. Thermax CP5 The Thermax CP5 is an industry proven performer, built to endure the most demanding carpet and upholstery extraction cleaning applications.
CP3 Warranty The Thermax CP3 is warranted to be free from Manufacturers defect for a period of one (1) year on all non-electrical and electrical components. 1) Warranty extended only to original owner. Proof of purchase required. Brass quick-disconnects, “O” rings, diaphragms, seals, grommets, gaskets, or any rubber or synthetic rubber or rubber-like parts are considered expendable in normal use and service, therefore are not included in this warranty.
____________________________________________________________________________________________ Name of Distributor ____________________________________________________________________________________________ Distributor Phone Number ____________________________________________________________________________________________ Date of Purchase ____________________________________________________________________________________________ Serial Number PLEASE NOTE: Retain this owner’s manual along with your copy of