product image) Manual

- 35 -
Appendix 4: External Relays
The relays on the Alpha pH 190 series controller are rated for 6
amps at 110 VAC and can be wired directly to your final control
element (provided its power requirements does not exceed this).
However, to preserve the life of your controller, or if higher power is
needed, it is recommended that you use the controller relay to drive
an external relay.
Diagram below shows a typical installation. Wiring should be
changed appropriately if normally closed (N.C.) operation is desired.
+
4 - 20 mA
12
19
3
11
18
2
10
17
19
16
8
15
7
14
6
13
54
NC NC NC NC
-
4 - 20 mA
RELAY 1 - NO
RELAY 1 - POLE
RELAY 1 - NC
Pt 100 - GND
RELAY 2 - NO
Pt 100 - IN
RELAY 2 - POLE
Pt 100 - SEN SE
GROUND RELAY 2 - NC
N
LIQUI D GND
L
pH/ORP
WARN ING
10 9