Installation Manual

Accu-Wave Chapter 1 Introduction
TN Technologies 1-5
Automatic verification and error correction software continuously monitors system
operations. System faults can be programmed to set off alarms.
How to Use This Manual
This manual provides installation and maintenance/troubleshooting procedures for the
Accu-Wave gauge.
Installation and Maintenance
Note: Reduced-size copies of the drawings referenced in this manual are
included in .
Chapter 2, “Hardware Installation,” provides instructions for mounting the Accu-Wave
sensor and transmitter.
Chapter 3, “Wiring Procedures,” describes how to wire the power source to the gauge and
other wiring, such as the current output and serial communications.
Additional Information
Appendix A, “How to Return Equipment for Service,” gives you shipping information for
returning equipment to TN Technologies for service.
Appendix B, “Parts List,” lists the parts of the Accu-Wave. Refer to this list if you need
to order parts.
Appendix C, “Specifications,” contains the specifications for the Accu-Wave.
Appendix D, “Installation Drawings,” contains reduced-size copies of the drawings
referenced in this manual.
Setting Up and Using the Gauge
The companion manual “Accu-Wave Operation Manual” (717791) provides detailed
information on how to set up the Accu-Wave software and operate the Accu-Wave
gauge.
TN Technologies’ Service Department
The TN Technical Services Department is available to help you with any problems you
may have installing or operating your gauge. Call us with your questions or comments:
• Phone: [phone] (US only)
• Main Office: (512) 388–9100
• FAX: [phone]