Operating Manual

Chapter 9 Security, Service & Diagnostics Accu-Wave
9-12 TN Technologies
Factory Service & Related Items” Menu (cont.)
[Service only item]
Display Comments
signal diagnostics→→
Menu subgroup header. See “Signal diagnostics”
menu table below.
Factory test
!!! Erases ALL !!!
←←Reject command
EXECUTE CMD→→
Performs an in-depth test of the system. Test takes
several minutes to complete and erases all setup data.
View menu, special
measurement, alarm &
command codes→→
NEXT↓↓
Allows you to scroll through a list of the codes for
commands, special measurements (add offset of 1024
to measurement number), and alarms.
Do not use break tab
distance correction
Change to “Do”→→
Continue as is.↓↓
Hardware Diagnostics (Factory Service Submenu)
Display Comments
hardware status:
DSP BRD
Indicates DSP board is installed.
hardware status:
relays installed
Indicates relays are installed.
Soc 1 board type:
current-relay
Board type installed in transmitter PCB slot #1.
Soc 2 board type:
none
Board type installed in transmitter PCB slot #2.
Soc 3 board type:
DSP
Board type installed in transmitter PCB slot #3.
Soc 4 board type:
none
Board type installed in transmitter PCB slot #4.
current outputs = 1
Number of current outputs installed.
relays = 2
Number of relays installed.
Switch INPUTs = 2
Number of contact closure inputs installed.