User's Manual

Thermo Electron Corporation AutoRADIO User Guide 3-1
Chapter 3
Set Up
1. Install the antenna to the radio board.
2. Apply power to the radio via the 2-position .200” connector on the
serial PC cable. Observe polarity.
3. Connect the diagnostic cable from the PC to JP2 (see Figure 1–1).
Using the AutoRADIO startup software, you can fine tune certain
parameters in order to optimize performance. When you open the software,
the startup screen appears.
Figure 3–1.
Select the correct communications port from this screen. The remaining
fields are read-only.
Click the Setup button to continue. On the following screen, click the
Search Connected Radio tab, and the screen displays information
pertaining to the connected instrument.
Hardware
Configuration
Software S
tartup