Datasheet

Datenblatt
Polyimid-Heizelement
Datasheet Polyimide-heater
thermo Artikelnummer:
thermo item no.:
Nennspannung:
24V AC/DC
Nominal Voltage:
Nennleistung:
20W +/-10% Wärmestromdichte: 0,091 W/cm²
Effective Output: Watt density:
0,589 W/in²
Abmessungen:
147 x 149 mm / Dicke ca.: 1,6 mm
Dimensions:
57,9 x 58,7
inch
/
Thickness approx.:
0,6299 inch
Sicherheitsthermostat (STB):
nicht vorhanden
Safety thermostat:
N/A
Temperatursensor:
nicht vorhanden
Temperature sensor:
N/A
Oberflächentemperatur ca.:
> 62 °C
Surface temperature approx:
> 144 °F
Beschreibungstext:
Description:
Dauer-Betriebstemperatur:
Bedingt durch das Klebeband ca. 120 °C - 150 °C
Duration operating temperature:
Due to the adhesive tape approx. 248 °F - 302 °F
RoHS und REACH konform:
ja
RoHS and REACH compliant:
yes
Schutzgrad:
IP X4
Degree of Protection:
Bemerkung:
Comment:
Achtung: Aufgrund hoher Heizleistung, bezogen auf die Fläche, kann
die Heizfolie je nach Einbausituation, ohne ausreichende Kühlung oder
Temperaturregelung, überhitzen und dadurch zerstört werden!
Attention: Overheating and the resulting destruction, as a
consequence of high heating power of the heating foil, can be
prevented by providing enough cooling or temperature control,
depending on the positioning of the high power heating foil.
Polyimid-Heizelement
147 x 149 mm, 24V AC/DC, 20W +/-10%, Unterseite selbstklebend,
Silikon-Anschlusslitzen AWG 22 x 80 mm
3626151
Heizelement frei in der Luft hängend, die Wärmeabgabe
erfolgt nur an die Umgebungsluft (Raumtemp. ca. 20 °C)
Temperature was measured with the heater suspended
freely in the air, the heat was only given off to the ambient
air (approx. 68 °F)
Stand: 18.11.2022- MiM Technische Änderungen und Irrtümer vorbehalten!

Summary of content (1 pages)