Operating Instructions and Installation Instructions

Page.6
4. REMOTE CONTROL
Please note:
Before the device is switched on, the air supply flue gas discharge valve must be opened.
The control knob is located front-right in the unit. If this valve is not open, the unit will not function
4.1 General
* The unit is operated using a radio-controlled remote control. This consists of a manual transmitter and a re-
ceiver. The receiver is connected to the gas control block.
* The receiver and the gas control block are located in the operating box.
4.2 Manual transmitter
* The transmitter uses a radio-controlled signal. The signal code is set at the factory
4.3 Screen setup
* After the batteries have been inserted, press the OFF
button and (small) at the
same time to toggle between °F (and 12 hour clock) and °C (and 24 hour clock).
* Wait a moment or press OFF to return to MAN mode.
4.4 Setting the time
* Press (large) and
(small) at the same time to go to the SET mode or program-
ming mode.
* The time can be set while the screen is flashing.
* Press to set the hour and minutes.
* Wait a moment or press OFF to return to MAN mode.
Manual transmitter
230 °C
20.59