Installation Guide

Installation Guide

You’ll need:

 Heavy staple gun

 Silicone Sealant

Remove ThermoClimb from the bag and double

check your attic door and stair dimensions. (Your

ThermoClimb is 59” x 25” x 13” tall)

Spread your ThermoClimb around the frame of

your attic stairs. Make sure the zipper end where

you enter into the attic!

You will then use a staple gun to staple the bottom

of the edges against the frame.

PAGE 1
Installation Guide You’ll need:  Heavy staple gun  Silicone Sealant Remove ThermoClimb from the bag and double check your attic door and stair dimensions. (Your ThermoClimb is 59” x 25” x 13” tall) Spread your ThermoClimb around the frame of your attic stairs. Make sure the zipper end where you enter into the attic! You will then use a staple gun to staple the bottom of the edges against the frame.
PAGE 2
Adjust the Velcro straps on the outside of the ThermoClimb to fit snugly against and around the frame. Use a stapler to staple flat the cover to keep air from escaping. Put a bead of silicone sealant along the gaps as close as you can to the stapled foot. You will notice an improvement in your insulation almost immediately. Thank you from Remington Solar Check out our solar attic fans at RemingtonSolar.