User's Manual

10.0 Sensors and Monitor Placement

IMPORTANT:

To ensure no signals are lost from sensor to monitor, make sure

that the monitor and sensors are always in an upright, vertical position.

NOTE:

To stand monitor on ﬂ at surface, use built in stand located on the back of

the unit.

For positioning using a nail, screw or hook:

1. Fasten nail, screw or hook (not included) to wall.

2. When positioning the monitor, remove rubber stopper in the wall mount hole

located at the back of the monitor.

3. Hang unit on the wall using the wall mount hole on the monitor, and/or on the

wall mount bracket included with the sensor.

For positioning using double sided tape (sensor only):

IMPORTANT:

before positioning monitor or sensors, ensure wall surface is clean

and residue free.

1. Remove one piece of double sided tape from the sheet provided.

2. Stick the tape vertically across the center of a sensor.

3. Peel off the backing paper from the tape.

4. Position by pressing sensor ﬁ rmly against the wall.

Monitor

Sensor

NOTE:

when installing the sensors in large refrigerators and/or freezers, it is

NOTE: when installing the sensors in large refrigerators and/or freezers, it is NOTE:

best to use the extension cord to mount the probe in the back half of the area

being monitored. Approximately half way from the ﬂ oor to ceiling will give optimal

readings.