User's Manual

Cable Preparation for Vertical Mounting

1. Run the cable that is already fastened to the wind

sensor through the vertical joining section (see

right).

2. Run the cable through the extension pole but do not

secure the pole to any sections yet.

3. Now run the cable through the top of the base-

bracket and then through the small rectangular

section found on one side of the base-bracket.

NOTE: Make sure that you completely pull the cable

through the wind sensors extension pole and base-

bracket to reduce the amount of slack on the cord.

Vertical Mount

1. Make sure that the wind vane can rotate freely

before fastening the unit permanently into position.

2. Insert one end of the extension pole provided into

the base-bracket.

3. Secure the connection point of the extension pole

and base-bracket using the 0.25” metal screws

provided to prevent rotation at the joining point.

(Use 4 x 0.25” screws to ensure stability).

4. Insert the vertical joining section on the bottom of the wind sensor into the top of the

extension pole. (Ensure that you pull all cable slack through the side of the base-bracket

to prevent creasing or cutting the cable).

5. Secure the wind sensor to the extension pole using the 0.25” screws provided to make

sure that the pole connection does not rotate. (Use 4 x 2.75” screws to ensure stability).

IMPORTANT: For accurate readings, it is important to mount the wind sensor so that the



compass to determine north.



NOTE: Make sure that when you are securing the base bracket with the 2.75” screws, you

are aware of the cable. Prevent driving a screw through the cable!

NOTE: For proper wind speed measurement ensure the vertical joining section is at 90º the

horizon

(Fig.A).

Horizontal Mounting

Cable Preparation for Horizontal Mounting

1. Run the cable that is already fastened to the wind sensor through the horizontal joining

section (see below).

2. Run the cable through the extension pole but do not secure the pole to any sections yet.

3. Now run the cable through the top of the base-bracket and then through the small

rectangular section found on one side of the base-bracket.

NOTE: Make sure that you completely pull the cable through the wind sensor’s extension pole

and base-bracket to reduce the amount of slack on the cord.

Horizontal mount - using a mast/antenna/pole

NOTE: It is not recommended to secure the wind sensor horizontally from a wall or chimney

