User's Manual
6
MOUNT WITH “N” FACING NORTH:
N” (north) on
the casing is facing the correct direction (north). If necessary, use a standard compass to
determine north.
1. Make sure that the wind vane can rotate freely before fastening the unit permanently.
2. Using the 2 x U-bolts, 4 x nuts and 4 x washers, secure the base-bracket of the wind
sensor to a stable mast/antenna/pole. (Masts made of magnetic materials, such as lead or
other dense metals will cause faulty readings).
IMPORTANT: Make sure that the pole insert of the base-bracket is facing north (N) and pilot
holes are on the top AND bottom.
3. Use the extension pole provided to distance the wind sensor from the stable mast/
antenna/pole. Insert one end of the extension pole into the base-bracket.
4. Secure the connection point of the pole extension and base-bracket using the 0.25” screws
provided to prevent rotation at joining point. (Use the 4 x 0.25” screws to ensure stability).
5. Insert the pole extension into the horizontal joining section. (Ensure that you pull all cable
slack through the side of the base-bracket to prevent creasing or cutting the cable).
6. Secure the horizontal joining section to the mount pole using the 0.25” screws provided to
make sure that the pole connections does not rotate.
4.0 Weather Forecast Function
4.1 Operation
WEATHER SET” button for 3 seconds, the
-” or
+WEATHER SET
may not be accurate if the current weather entered is not correct.
weather status is entered.
4.2 Weather Conditions
There are 5 different weather conditions in the weather forecast.
NOTE: The Freezing or snow icon will only appear if the weather forecast is Rainy and the
outdoor temperature is below 0°C.
SUNNY PARTLY CLOUDY CLOUDY RAINY STORMY