Operation Manual

ledoMlatnoziroH ledoMlacitreV
WgnitaR0570001052100510002000100510002
)mm(htdaerB1949367875397511864
)mm(thgieH211601
)mm(htpeD516261148316061
)gk(thgieW5,114,5191325,135,528253
2-2) Connect the panel heater :
55
55
5
- The panel heater must be powered with 220-240V 50Hz
- The panel heater must be connected to the mains by a 3-
wire cable (Brown= Phase, Blue=Neutral, Black=Pilot wire)
by means of a connection box. In humid areas such as
bathrooms and kitchens the connection box must be installed
at least 25 cm above the floor.
- Do not connect the unit to earth.
Do not connect the pilot wire ( black ) to earth.
- The heater must be installed by a qualified electrician in
accordance with the local regulations. The heater and the
pilot (black) wire must NOT be connected to earth. If the
heater wire is damaged, it must be replaced by a qualified
person to avoid hazard.
- If a pilot or piloted panel heater is protected by a 30mA
differential (e.g. bathroom) the pilot wire’s power supply.
Table of commands the panel heater can receive on its pilot wire. To be measured between the pilot wire and the neutral.
55
55
5
sdnammoC
devieceR
tnerrucoN
etelpmoC
V032noitanretla
-flahevitageN
V511-noitanretla
-flahnoitisoP
V511+noitanretla
epocsollicsO
lartueN/féR
edoM
deniatbo
trofmoCocEeerftsorFpotStuCrewoP
Note : leave the spacer under the device until it is
secure on the wall support.
The retaining tabs under the horizontal devices are designed to keep the device standing while the
support is being attached to the wall. The device must never be allowed to heat while standing on
these tabs.
44
44
4ter
44
44
4bis
Trace
and
bore
Trace
Bore
Screw
Screw