User guide

Form #19642B
Rev. 01/17/08
Fig. B
Mounting Flange
Mounting Bushing
White Mechanism Plate
Mechanism
Fig. C
Fig. A
Power supply
connector
Mechanism
End Cap
Mechanism
Lead Screw
Overow Tube
newer plate shape
older plate shape
Water sup-
ply hookup
Tools needed
• Flat-bladescrewdriver
• AdjustableWrench
•Pliers
•DAPDynaexCaulkorequivalent(availableatmosthardware
stores)
Note:
• Readallinstructionsbeforebeginningwork.
To Remove Toilet From Floor
1. TurnoffRVwatersupplyperRVOwner’sManual.
2. Pressbothkeypadbuttonsatthesametime,twice,toopenbladeand
drainbowlofwater.If mechanism does not work, you will have to open
the valve manually. Remove the Sound Deadening Insulation (if present)
from the back of the mechanism to access the Mechanism Lead Screw
(Fig.A)
. Turn the knob shown if present or use a 5/16” socket wrench to
turn the screw and open the valve.
3. PryoffBoltCapswithFlat-bladescrewdriver.Usewrenchtoremove
1/2-inchLagScrews.
4. SwivelToilettogainaccesstoback.
5. TurnoffRV’spowersupplytotheToilet.
6. DisconnectToilet’s12-voltpowerhookuptoRV.
7. DisconnectWaterSupplyLinefromelbowconnectorbyhand.Use
AdjustableWrenchifnecessary,withcare.
8. Placeanoldtowelorsoftclothonworksurface.RemoveToiletfromoor
andplaceupside-downonworksurface.
9. RemoveoldClosetFlangeSeal(maybefoundintoiletorinooratCloset
Flange).Discard.
10. CoverHoldingTankopeningtocontainodor.
To Remove Old Part
1. Tapout2MountingBushings(Fig.B)andremoveMountingFlange.
2. High prole models only:RemoveExtensionTubefromMechanism
Assembly(ifitdidnotcomeoutwiththeMountingFlange).
3.
Remove4MechanismScrews(MS,Fig.C).
4. RemoveMechanismAssemblyfromwhiteMechanismPlate.
5. Loosen3WellNutScrews
(WN,Fig.C)
.PullMechanismPlatewith3
WellNuts/screwsfromchinatoiletbody.Discardplateandhardware.
6. ScrapeoffoldSealwithsharptool.Usemineralspiritstoremoveresi-
due.
To Replace Mechanism Plate
1. Applya1/4”widecontinuousringofcaulksealantaroundthetopofthe
exposedsideoftheatfoamseal.(Fig.E).
Mechanism Plate Package
Part #19624
NOTE: this Mechanism
Plate works only with units
manufactured after 7/6/01.
See label on lower front of
toilet bowl.
RVToiletService Parts
for
Aria/Aria Deluxe

Summary of content (2 pages)