Owner Manual

Owner’s Manual 13
Remove the Refrigerator
Your dealer or an authorized Thetford Service Center must do this procedure.
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on
the refrigerator, be careful and wear cut resistant gloves.
1. Close the valve at the LP gas tank(s).
To avoid possible LP gas leaks, always use two wrenches to loosen and tighten the LP gas supply line at
the refrigerator’s manual shut off valve.
2. Open the lower intake vent and remove the LP gas supply line from the 3/8 inch male are tting of the refrigerator.
3. Remove the AC power cord from the power point.
4. Remove the DC wiring from the refrigerator:
- Remove the DC wiring from the battery or the converter of the vehicle.
- Put a mark on the DC wires so you can put them back in the correct location.
- Remove the DC wires from the refrigerator.
5. Remove the screws which fasten the refrigerator to the oor.
6. Remove the door from the refrigerator if necessary.
7. Remove the screws which fasten the refrigerator to the wall.
8. Remove the refrigerator from the opening.
9. Attach the door to the refrigerator if necessary.
WARNING
!
CAUTION
!
WARNING
!
NOTICE
- Remove the are nut from the orice assembly [77] (See Art00956).
- Remove the orice assembly from the burner [78].
Do not try to remove the orice [79] from the orice adapter [80] when cleaning. Removal will damage
the orice and seal of the orice and can cause an LP gas leak. Leaking LP gas can ignite or explode
which can result in dangerous personal injury or death. Do not clean the orice with a pin or other
objects.
- Clean the orice assembly with air pressure and alcohol only.
- Using a wrench, assemble the orice assembly to the burner.
- Assemble the are nut to the orice assembly.
- Tighten the are nut by hand.
- Hold the orice assembly securely and, using a wrench, tighten the are
nut 1/4 revolution only.
- Examine all of the connections for LP gas leaks.
- Clean the burner box.
- Assemble the burner box cover.
- Assemble the drip cup.
Art 00956
77
78
79
80