Owner Manual

Owner’s Manual 14
Your dealer or an authorized Thetford Service Center must do this procedure.
Make sure the combustion seal is not broken, is completely around the refrigerator mounting anges, and
is between the mounting anges and the wall of the enclosure. If the combustion seal is not complete,
exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Remove the door from the refrigerator.
3. Put the screws though the mounting anges and into the wall.
4. Attach the door to the refrigerator
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on
the refrigerator, be careful and wear cut resistant gloves.
5. Open the lower intake vent and put the screws through the refrigerator rear corner brackets and into the oor.
To avoid possible LP gas leaks, always use two wrenches to loosen and tighten the LP gas supply line at
the refrigerator’s manual shut off valve.
6. Attach the LP gas supply line to the manual shutoff valve of the refrigerator.
7. Open the valve at the LP gas tank(s).
Do not allow the leak checking solution to touch the electrical components. Many liquids are electrically
conductive and can cause a shock hazard,electrical shorts, and in some cases re.
8. Examine the gas supply line for leaks.
9. Connect the DC wiring to the refrigerator:
- Install the DC fuse or connect the DC wiring to the battery or the converter.
- Connect the DC wires from the refrigerator.
10. Connect the AC power cord to the receptacle.
Reinstall the Refrigerator
Replacement Parts
You may purchase replacement parts through your local Recreational Vehicle dealer or an authorized Thetford Service Center.
CAUTION
!
NOTICE
WARNING
!
WARNING
!
WARNING
!