Owner Manual
Owner’s Manual 6
A
Auto Mode
230VAC
12VDC
Gas
The refrigerator control automatically selects the power source. The control selects AC
electric rst. If AC electric is not available, the control selects DC electric. If DC electirc is
not available, the control selects LP gas.
The refrigerator operates on AC electric.
The refrigerator operates on DC electric.
The refrigerator operates on LP gas.
Selecting the cooling level:
- Press and hold the conrmation button for two (2) seconds.
- The current mode indicator [276] will start to ash.
- Press the conrmation button again so that the cooling level indicators [308] start to ash.
- Press either of the selector switches until the desired cooling level is illuminated.
- Press the conrmation button to set the cooling level.
minimum cooling level maximum cooling level
If the cooling load changes, you must manually change the thermostat to maintain the same temperature inside the
refrigerator.
When the outside air temperature is below 10° C, the refrigerator may have a tendency to freeze food at the colder temperature
settings. To reduce the tendency to freeze food:
- Set the refrigerator controls to a lower cooling level.
- Keep the refrigerator full.
- Put foods that are more likely to freeze on the lower shelf.
Cooling unit ventilation fan:
This refrigerator is equipped with a fan, which is located on the rear of the refrigerator. The fan improves the refrigerator performance
when the ambient temperature is more than 38°C. The fan switch [252] is located on the front control. (See Art02519)
The thermostat controls the fan when the fan switch is turned on. The fan will
come on intermittently depending on ambient temperature. The fan will not
operate when the fan switch is turned off, regardless of ambient temperature
The fan requires 12VDC power. Before turning the fan on, make sure that the
refrigerator is connected to 12VDC power and the vehicle battery has sufcient
capacity.
NOTICE
252
ART 02519