Owner Manual

Owner’s Manual 7
Ignition – LP gas operation
- Open the valve on the LP gas storage tank.
- Put the refrigerator into LP gas mode.
- Set the refrigerator at the maximum cooling setting.
You will hear a clicking sound indicating that the controls are sending a spark to the burner. If the ame does not
ignite within 30 seconds, the gas safety valve will close and the gas indicator ( ) and temperature LEDs will begin
to ash. After a two minute delay, the refrigerator will try to relight the gas. You can wait for the two minute delay or
switch the refrigerator off and on and select the gas source again.
- If the ame does not ignite after several attempts, contact your dealer or authorized Thetford Service Center.
- When the burner lights, set the refrigerator to the desired cooling level.
Start up – AC operation
- Make sure that 230VAC power is available to the refrigerator.
- Put the refrigerator into AC mode ( ).
- Set the desired cooling level.
Start up – DC operation
- Make sure that 12VDC power is available to the refrigerator.
- Put the refrigerator into DC mode ( ).
- Set the desired cooling level.
Shut down:
Press and hold the on/off button for two (2) seconds. All LEDs will turn off.
NOTICE