BUILD IN APPLIANCES FOR USE WITH LIQUIFIED PETROLEUM GAS MODELS S~OH70000 S~OH76000 (LPG) S~OH71000 S~OH77000 (DUAL FUEL) PCC 1265 – Issue 10 - GB USER AND INSTALLATION INSTRUCTIONS • WARNING • Read the instructions before use • Only use appliance in a well ventilated area Install the appliance in accordance with the regulations in force For use in GB NL DE FR ES PT IT SE NO DK SI SK THETFORD LIMITED UNIT 19 Oakham Drive, Parkwood Industrial Estate Rutland Road, Sheffield S3 9QY, ENGLAND.
WARNINGS • Appliance and accessible parts become hot during use. • Avoid touching heating elements. • Children less than 8 years of age shall be kept away unless continuously supervised. • This appliance can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities and/or lack of experience and knowledge only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
TRIPLEX COOKER RANGE TRIPLEX S~OH70000 and S~OH71000 TRIPLEX ‘WIDE’ S~OH76000 and S~OH77000 + 2.0 + 2.0 W = 445mm /-0.0 #1 = Side battons (optional) 15x40x330 #2 = Worktop Cutout 493mm W = 496mm /-0.
MINIMUM DISTANCE TO COMBUSTIBLE MATERIAL • Recommended minimum dimensions to combustible material • Installers should verify with furniture manufacturer suitability of materials T ≥ 10mm X ≥ 200mm V ≥ 400mm Y & Z ≥ 500mm WIRING DIAGRAM 1 5 GREEN & YELLOW RED 2 6 BLUE YELLOW 3 7 BROWN PURPLE 4 8 BLACK WHITE #1 CABLE CLAMP EARTH- FASCIA SUPPORT BRACKET #2 ROTARY SWITCH EARTH-BURNER SUPPORT FRAME #3 WARNING LAMP HOTPLATE CONNECTIONS #4 HOTPLATE #5 #6 4 #7
SPECIFICATION 5
INTRODUCTION This appliance must be installed in accordance with the local, national and European regulations in force. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using the appliance The appliance is designed for either high or low level installations. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.
OPERATION Gas Burners (1) Ensure gas supply is connected and turned on. (2) Push in the control knob and turn anticlockwise to full rate – large flame ( ). (3) Continue depressing the knob whilst holding a lighted match to the burner. (4) After the burner is lit continue depressing the knob for approximately 10 - 15 seconds. (5) Release knob and turn to required heat setting. (6) If burner has not lit within 15 seconds, release knob and wait at least 1 minute before repeating operations (2) to (5).
OPERATION • • • • The control tap on this appliance operates both the Grill and Oven burner. To ensure safe operation it is not possible to operate both burners at the same time. The grill must only be used with the door open Prior to lighting the grill the heat deflector below the fascia should be pulled out. Never adjust the heat deflector without using hand protection – ie oven gloves. Using The Grill (1) Ensure gas cylinder/supply is connected and turned on.
OPERATION Using The Oven (1) Ensure gas cylinder/supply is connected and turned on. (2) Open door, push in the control knob and turn to full rate (Gas Mark 9, 240°C). (3) Continue depressing the knob whilst holding a lighted match to the burner. (4) After the burner is lit continue depressing the knob for approximately 10 - 15 seconds. (5) Release the knob and turn to required heat setting.
OPERATION Gas Mark ¼-½ 1 2 3 4 5 6 7 8 9 Temperature (Centre of Oven) 265-275ºF 130-135ºC Very cool 285 140 Cool 300 150 Cool 330 165 Warm 355 180 Moderate 385 195 Fairly hot 410 210 Hot 430 220 Hot 445 230 Very hot 465 240 Very hot Dish Meringues Stewed fruit Rich fruit cake, rice pudding Baked custard, shortbread fingers Victoria sandwich Whisked sponges, ginger nuts Short crust pastry Bread, scones, flaky pastry Puff pastry Quick browning Do's And Don'ts DO DO DO DO DO DO DO NOT DO NOT DO NOT DO NOT
INSTALLATION Regulations And Standards In your own interest of safety, it is law that all gas appliances are installed and serviced by an approved competent person, in accordance with the local and National/European standards in force. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using this appliance.
INSTALLATION The performance of this appliance meets the requirements of the European Standard for Domestic Cooking Appliances (EN30) which specifies a maximum allowable temperature rise of the furniture into which the appliance is installed of 65oC above the ambient temperature. The installer should verify all furniture materials are suitable – ie plastic materials may have a softening point lower than specified above.
INSTALLATION To ensure correct operation and prevent changes in air pressure affecting oven performance we recommend the following installation requirements:• Built into self contained cabinet which is not connected to externally vented chambers in adjacent furniture, other than correct size gas dropouts. • Holes for cables & pipes have minimum clearance where possible • A gas escape hole MUST be fitted.
SERVICING 1. Disconnect from gas supply Lift and remove the bottom plinth to gain access, then disconnect the gas supply. If the appliance is Dual Fuel, disconnect/isolate the electric supply. 2. Remove hob surface Disconnect from gas supply (1) and electric supply if Dual Fuel. Lift off the Panrest and remove the two screws securing each burner spreader. Remove front fascia by removing all push on control knobs and unscrew the two recessed fixed nuts and both fascia retaining screws.
SERVICING Spark Ignition Continued ……… 12v Spark Generator replacement - Located at the rear of appliance. Remove all electrode wires, unscrew the two retaining screws and lift off the unit. 7. Grill burner injector (No62) Disconnect from gas supply (1). Remove appliance from housing (2). Release the locking screw on the injector holder, disengage the grill pipe from the control and remove the injector. 8.