Operation Manual

ManualsBrandsThetford ManualsCooktopsSERIE 930

BUILD-IN COOKING HOB

FOR USE WITH LIQUIFIED PETROLEUM GAS

TOPLINE HOB

INSET SERIES 160, 162, 164, 167

TOP MOUNT SERIES 910, 920, 922, 930, 960

PCC

1272

–

Issue

USER AND INSTALLATION INSTRUCTIONS

READ AND RETAIN FOR FUTURE REFERENCE

FOR USE IN: GB, IE, FR, NL, BE, LU, ES, IT, NO, DE, DK, SE

THETFORD

LIMITED,

19 Oakham Drive

, Parkwood Industrial

Estate

Rutland Road, Sheffield S3 9QY, ENGLAND.

TEL: + 44 (0) 114 273 8157 FAX: + 44 (0) 114 275 3094

Summary of content (13 pages)

PAGE 1
BUILD-IN COOKING HOB FOR USE WITH LIQUIFIED PETROLEUM GAS TOPLINE HOB INSET SERIES 160, 162, 164, 167 TOP MOUNT SERIES 910, 920, 922, 930, 960 PCC 1272– Issue 7 - GB USER AND INSTALLATION INSTRUCTIONS READ AND RETAIN FOR FUTURE REFERENCE FOR USE IN: GB, IE, FR, NL, BE, LU, ES, IT, NO, DE, DK, SE THETFORD LIMITED, 19 Oakham Drive, Parkwood Industrial Estate Rutland Road, Sheffield S3 9QY, ENGLAND.
PAGE 2
PAGE 3
PAGE 4
PAGE 5
CONTROL POSITIONS – ALL MODELS FIG. 1 OFF FULL RATE LOW RATE APPLIANCE LOCATION For either Inset or Top mounted appliances the minimum allowable distance to combustible materials is as shown below. FIG.
PAGE 6
FIG.
PAGE 7
FIG.
PAGE 8
WORKTOP CUTOUT DETAILS FIG.
PAGE 9
WORKTOP CLAMPING METHODS FIG. 6 SERIES 160, 162, 164 & 167 INSET HOBS (Top Mount Seal) FIG. 7 SERIES 160,162,164 & 167 INSET HOBS (Flush Mount Seal) FIG.
PAGE 10
INTRODUCTION GB This appliance is designed for cooking food, any other use is incorrect and dangerous. Failure to install the appliance correctly or improper use could invalidate any warranty or liability claims and lead to prosecution. This appliance must be installed in accordance with the local, national and European regulations in force. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using the appliance.
PAGE 11
OPERATION GB 1. Ensure gas supply is connected and turned on. 2. Push in the control knob and turn anticlockwise to full rate – large flame ( ) Fig. 1. 3. Continue holding the knob depressed whilst the automatic ignition lights the burner. For manual models hold a lighted match or taper to the burner. 4. After the burner is lit continue depressing the knob for approximately 10 - 15 seconds. 5. Release knob and turn to required heat setting – see Fig. 1. 6.
PAGE 12
INSTALLATION GB In your own interest of safety, it is law that all gas appliances be installed by an approved competent person who will undertake to work to safe and satisfactory standards. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution. This appliance shall be installed in accordance with the local and national/European standards in force. Particular attention shall be given to the requirements regarding ventilation.
PAGE 13
INSTALLATION GB On completion of the installation a warning notice complying to EN721 Annex A should be affixed adjacent to the appliance. If other appliance/s are located below the hob we recommend conducting a temperature verification test to confirm any rise in temperature of the cabinet materials are within allowable limits and meet requirements specified in EN30-1-1, EN1949, EN1645-1, EN1646-1, EN1647, EN721.