BUILD IN APPLIANCE FOR USE WITH PROPANE GAS MODELS: S~OH72000 MK3 CAPRICE (ALL GAS) S~HG72000 MK3 MINIGRILL (ALL GAS) S~OH73000 MK3 CAPRICE (DUAL FUEL) S~HG73000 MK3 MINIGRILL (DUAL FUEL) USER AND INSTALLATION INSTRUCTIONS PCC 1299DFZ – Issue 6 PLEASE READ THOROUGHLY AND KEEP FOR FUTURE REFERENCE FOR USE IN AUSTRALIA THETFORD AUSTRALIA PTY LTD 41 LARA WAY CAMPBELLFIELD VIC TEL: 03 9358 0700 FAX: 03 9357 7060
INTRODUCTION This appliance must be installed in accordance with the manufacturers installation instructions, local gas fitting regulations, municipal building codes, AG5601 and any other relevant statutory regulations. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using the appliance The appliance is designed for either high or low level installations.
OPERATION • • • • The appliance is not intended for use by young children or infirm persons, without supervision Young children should be supervised to ensure they do not play with the appliance. Glass lids may shatter when heated. Turn off all burners before shutting the lid Spillage on the surface of the lid should be removed before opening the lid. Burner operation The burners on this appliance have fixed aeration and no adjustment is required.
OPERATION • • Glass lids may shatter when heated. Turn off the hotplate and allow it to cool before closing the glass lid. Remove all spillage from the surface of the glass lid before opening. Using the Electric Hotplate Ensure the electricity is switched on. The hotplate control is numbered from 1 to 6. To turn it on, rotate the knob either clockwise or anti-clockwise to the required position. Position 1 is the coolest setting.
OPERATION • • • The pan supplied with the appliance is multi functional, for use in grill or oven. The handle can be removed or inserted whilst the pan is in use. Always remove the handle when the pan is in use. Using the Grill 1. Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at gas cylinder/mains and contact supplier. 2. To light: Open door, push in the control knob and turn to full rate – large flame ( ).
OPERATION • • • The pan supplied with the appliance is multi functional, for use in grill or oven. The handle can be removed or inserted whilst the pan is in use. Always remove the handle when the pan is in use. Using the Oven 1. Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at gas cylinder/mains and contact supplier. 2. To light: Open door, push in the control knob and turn to gas mark 9.
OPERATION Care should be taken not to overload the oven, allow adequate spacing to ensure free circulation of heat. When roasting with aluminium foil ensure the foil does not impair circulation of heat or block anythe oven flue outlet.
INSTALLATION Regulations and Standards This appliance must be installed in accordance with the manufacturers installation instructions, local gas fitting regulations, municipal building codes, AG5601 and any other relevant statutory regulations. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using the appliance Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.
INSTALLATION Fixing This appliance can be front or side fixed, holes are provided for either installation method. Front Fixed Appliance 1 front fix hole each side of Grill opening 1 front fix hole each side of Oven opening 2 fixing holes in each Hotplate side trim Side Fixed Appliance 1 side fix hole each side of Grill opening 1 side fix hole each side of Oven opening 2 fixing holes in each Hotplate side trim Make sure the appliance is fully home in the cabinet/aperture prior to screw fixing.
MAINTENANCE & SERVICING • • • • • Shut off gas supply at isolating valve, switch off electric supply and ensure all parts are cool before cleaning or servicing All servicing must be carried out by an approved competent person. After each service the appliance must be checked for gas soundness This appliance must not be modified or adjusted unless authorized and carried out by the manufacturer or his representative. No parts other than those supplied by the manufacturer should be used on this appliance.
MAINTENANCE & SERVICING 5. Remove the grill burner assembly Shut off both gas & electric supply. Remove the hob surface (2). Release the locking screw on the injector holder. Unscrew the thermocouple from the control and remove the spark ignition lead from the generator. Lever off starlock washers from the grill flue, remove flue clamping screw from rear cross strut and remove flue. Remove clamp screw retaining grill assembly to roof of cavity. Slide and lift out the complete grill assembly. 6.