Owner manual

Get Application Commands
Command Set 169
Get Application Commands
The Get commands listed in the following table are used to get settable parameters from
the Mercury Embedded module. All of the commands have a data length of zero, and
return data or a fault code.
Applications Commands – Get
Error Status Codes
 FAULT_MSG_WRONG_NUMBER_OF_DATA – 100h
 FAULT_MSG_INVALID_PARAMETER_VALUE - 105h
 FAULT_AHAL_TRANSMITTER_ON – 502h
OpCode Command Name Bootloader App Firmware
0x10
Get Hardware Version (10h)
YY
0x61
Get Antenna Configuration (61h)
NY
0x62
Get Read TX Power (62h)
NY
0x63
Get Current Tag Protocol (63h)
NY
0x64
Get Write TX Power (64h)
NY
0x65
Get Frequency Hop Table (65h)
NY
0x66
Get User GPIO Inputs (66h)
NY
0x67
Get Current Region (67h)
NY
0x68
Get Power Mode (68h)
NY
0x69
Get User Mode (69h)
NY
0x6A
Get Reader Configuration(6Ah)
NY
0x6B
Get Protocol Configuration (6Bh)
NY
0x6C
Get Reader Statistics (6Ch)
NY
0x70
Get Available Protocols (70h)
NY
0x71
Get Available Regions (71h)
NY
0x72
Get Current Temperature (72h)
NY