Operating Manual

SETTING-INTO-OPERATION
Setting-into-operation takes place by quickly pressing
the ON key.
The following display appears:
Display
Page 7
SNR ...........................s erial number of the Orderman
V1.51E ............................................. Software version
Before the first setting-into-operation, verify the
settings in the Setup menu.
No radio connection
If no radio connection to a radio frequency basis
station exists (i.e., outside of the radio range), digits
appear on the display in the upper right-hand corner.
These display the radio channel change. The
Orderman attempts to pick up radio connection to a
radio frequency basis station.
Note: Inverse-displayed digits can also mean that
the entered data cannot be accepted by the
host computer.
SETTING-INTO-OPERATION
Setting-into-operation takes place by quickly pressing
the ON key.
The following display appears:
SNR ...........................s erial number of the Orderman
V1.51E ............................................. Software version
Before the first setting-into-operation, verify the
settings in the Setup menu.
No radio connection
If no radio connection to a radio frequency basis
station exists (i.e., outside of the radio range), digits
appear on the display in the upper right-hand corner.
These display the radio channel change. The
Orderman attempts to pick up radio connection to a
radio frequency basis station.
Note: Inverse-displayed digits can also mean that
the entered data cannot be accepted by the
host computer.
Special Keys
The display contrast can be modified by combining
the following keys:
ON + ............................................. increase contrast
ON + ............................................ decrease contrast
This modification is not permanently stored and is
only valid until switching off the Orderman. For a
permanent modification,see the chapter "Set-up
Menu".
DISPLAY
Setting-into-Operation
Page 12
Display
Page 7
Setting-into-Operation
Page 12
2 sizes of lettering are available:
- 6 x 8 matrix
- 8 x 14 matrix
Depending on the lettering and its size, up to 8 lines
with 21 characters each can be displayed.
Graphics can likewise be shown on the display.
General Reference
The display can be randomly controlled from the
application program on the host computer. Refer to
the description of the application program on the
different display layouts (input masks, etc.)
Special Keys
The display contrast can be modified by combining
the following keys:
ON + ............................................. increase contrast
ON + ............................................ decrease contrast
This modification is not permanently stored and is
only valid until switching off the Orderman. For a
permanent modification,see the chapter "Set-up
Menu".
DISPLAY
2 sizes of lettering are available:
- 6 x 8 matrix
- 8 x 14 matrix
Depending on the lettering and its size, up to 8 lines
with 21 characters each can be displayed.
Graphics can likewise be shown on the display.
General Reference
The display can be randomly controlled from the
application program on the host computer. Refer to
the description of the application program on the
different display layouts (input masks, etc.)
®
ORDERMAN
think
dig
High Tech Solutions
think
dig
High Tech Solutions
®
ORDERMAN
®
ORDERMAN
think
dig
High Tech Solutions
think
dig
High Tech Solutions
®
ORDERMAN