Tablet Accessory User Manual

ManualsBrandsThink Outside ManualsComputer AccessoriesTablet Accessory

Stowaway

Universal Bluetooth

Keyboard

for Pocket PC

Quick Start Guide

Before installing the Stowaway Universal Bluetooth Keyboard application on your Pocket PC device,

it is a good idea to back up your data using ActiveSync

. Please delete any other keyboard software

you have previously installed on your device to avoid potential conflicts.

This software application enables your handheld device to interact with the external keyboard. You

will need at least 300KB of memory for the keyboard application.

Battery Installation:

1. Remove the battery door on the base of the keyboard.

2. Insert two (2) AAA batteries (included) inside the battery compartment.

3. Replace the battery door.

Opening and Closing the Keyboard:

1. To Open: Lift the stand, press the button on the left side of the keyboard and swing the right

section open.

Summary of content (3 pages)

PAGE 1
Stowaway® Universal Bluetooth® Keyboard for Pocket PC Quick Start Guide Before installing the Stowaway Universal Bluetooth Keyboard application on your Pocket PC device, ® it is a good idea to back up your data using ActiveSync . Please delete any other keyboard software you have previously installed on your device to avoid potential conflicts. This software application enables your handheld device to interact with the external keyboard. You will need at least 300KB of memory for the keyboard application.
PAGE 2
. To Close: Slide the tab right to unlock the keyboard, snap keyboard shut, depress stand with thumb and secure. Installing the keyboard application: 1. 2. 3. 4. 5. Connect your handheld device to its synchronization cradle/cable and establish a connection ® between the computer and your PDA using ActiveSync . Insert the CD-ROM into the CD-ROM drive on your PC. Follow the on-screen instruction to complete the installation. For proper operation, the driver must be installed into Main Memory.
PAGE 3
1. Setup a Secure connection. a. Scan and discover as described above, then check the Secure box and tap Connect. b. When prompted enter a numeric-only passkey (of your own choosing) on the PDA’s On-Screen keyboard using the stylus and tap OK. c. Type the same passkey on the keyboard using LFn+number and Enter. 2. Set the PDA to accept pairings from All devices. NOTE: This is a vulnerable configuration (consult the Owner’s Manual for details). a. On the PDA, open Bluetooth Settings. b.