Quick Start Manual

Table Of Contents

www.mythinkcar.com

THINKSCAN Plus

particulate matters from the trap, so that the performance of the trap is always stable. DPF

regeneration matching is required in the following situations:

a) replace the exhaust back pressure sensor;

b) disassembly or replacement of the particle trap;

c) removal or replacement of fuel additive nozzles;

d) removal or replacement of catalytic oxidizer;

e) the DPF regeneration fault lamp is lit and matched after maintenance;

f) repair and replace the DPF regeneration control module.

2.2.8 Anti-theft matching

In order to prevent the car from being used by illegal keys, the car’s anti-theft matching

function enables the car’s immobilizer control system to identify and authorize the remote

control key before the car can be turned on and used normally. In addition, when replacing

the ignition key, ignition switch, instrument cluster, engine control unit (ECU), body control

module (BCM), and remote control battery, it is necessary to match the anti-theft key.

2.2.9 Nozzle coding

Write the actual code of the fuel injection nozzle or rewrite the code in the ECU to the

code corresponding to the fuel nozzle of each cylinder, so that the fuel injection amount of

each cylinder can be controlled or corrected more accurately. Usually after replacing the

ECU and the fuel injector, the coding of each cylinder fuel nozzle needs to be conﬁ rmed or

recoded, thus the cylinder can better identify the fuel injector of each cylinder and control

the fuel injection accurately.

2.2.10 Tire pressure reset

When the car tire pressure fault indicator light is on, this function is to reset the tire

pressure and turn oﬀ the tire pressure fault indicator.

If the tire pressure is too low or leaks, replace or install tire pressure monitoring equipment,

and replace the tire. When the vehicle with a damaged tire pressure sensor and tire

pressure monitoring function has rotated its tires, the tire pressure reset must be carried

out after maintenance.

2.2.11 Suspension level calibration

This function can adjust the vehicle body height. When replacing the vehicle height sensor

or control module in the air suspension system or the vehicle level is wrong, this function

can adjust the vehicle height sensor for level calibration.

2.2.12 Headlight matching